Sony CDX-S2210 Operating Instructions - Page 4
Resetting the unit, Setting the clock, DEMO mode, Detaching the front panel - no sound
View all Sony CDX-S2210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Getting Started Resetting the unit Before operating the unit for the first time, or after replacing the car battery or changing the connections, you must reset the unit. Detach the front panel and press the RESET button with a pointed object, such as a ball-point pen. RESET button Note Pressing the RESET button will erase the clock setting and some stored contents. Setting the clock The clock uses a 12-hour digital indication. 1 Press and hold (SEL). The setup display appears. 2 Press (SEL) repeatedly until "CLOCK- ADJ" appears. 3 Press (DSPL). The hour indication flashes. 4 Press the volume +/- button to set the hour and minute. To move the digital indication, press (DSPL). 5 Press (SEL). The clock starts and the next setup display appears. 6 Press and hold (SEL). The setup is complete. To display the clock, press (DSPL). Press (DSPL) again to return to the previous display. With the card remote commander In step 4, to set the hour and minute, press M or m. Detaching the front panel You can detach the front panel of this unit to prevent theft. Caution alarm If you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the built-in amplifier is used. 1 Press (OFF). The unit is turned off. 2 Press , then pull it off towards you. (OFF) Notes • Do not drop or put excessive pressure on the front panel and display window. • Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray. Tip When carrying the front panel, use the supplied front panel case. Attaching the front panel Engage part A of the front panel with part B of the unit, as illustrated, and push the left side into position until it clicks. DEMO mode When the unit is turned off, the clock is A displayed first, then demonstration (DEMO) mode starts the demonstration display. B To cancel the DEMO mode, set "DEMO-OFF" in setup (page 7) while the unit is turned off. Note Do not put anything on the inner surface of the front panel. 4