Sony CMT-L7HD Primary User Manual - Page 27
HD - Recording, The Level Synchro Recording function is
View all Sony CMT-L7HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
HD - Recording Note When recording a CD, track numbers are marked when you paused recording. In addition, the tracks might be recorded as the same single track with a single track number when the same single track of the same CD is recorded repeatedly. • Any point during recording (Track Mark) You can mark track numbers during manual recording of any source. • After recording Use the Divide function (see page 34). This function is convenient when the source is tape or radio programs and the track numbers are not marked automatically. Marking track numbers automatically during recording - Level Synchro Recording The Level Synchro Recording function is factory set to on, so the track numbers are automatically marked. If "L-SYNC" does not appear during recording, turn on the Level Synchro Recording as follows. Track numbers are automatically marked when the input signal is continuously below a certain level for more than 1.5 seconds and then exceeds that level. 1 Press FUNCTION repeatedly until "HD" appears in the display. 2 While the system is stopped, press MENU/NO on the remote. "Edit Menu" appears in the display. 3 Press MENU + or - on the remote repeatedly until "Setup?" flashes in the display, then press ENTER/YES on the remote. 4 Press MENU + or - on the remote repeatedly until "T.Mark Off" (or "T.Mark LSync") appears in the display, then press ENTER/YES on the remote. 5 Press MENU + or - on the remote to select the setting, then press ENTER/ YES on the remote. To Select Turn on the Level Synchro Recording function T.Mark LSync. (factory setting) Turn off the Level Synchro Recording function T.Mark Off. 6 Press MENU/NO on the remote. To proceed to recording, follow the procedures about recording. To change the trigger level for Level Synchro Recording When the Level Synchro Recording is set to "On", track numbers are automatically marked when the input signal is below the trigger level set in this section for more than 1.5 seconds and then exceeds that level. The factory setting is "-50 dB". When the recording source is tape or radio program and the track numbers are not marked properly because of noise, set this level higher so that track numbers are marked easily. Perform the following procedure to change the signal level that triggers Level Synchro Recording. 1 Press FUNCTION repeatedly until "HD" appears in the display. 2 While the system is stopped, press MENU/NO on the remote. "Edit Menu" appears in the display. continued 27GB