Sony CMT-SV2D CMTDV2D Instructions (main component system) - Page 43
Tuner, Tape deck, Optional components, continued
View all Sony CMT-SV2D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
The angles cannot be changed. • Multi-angles are not recorded on the DVD being played. • The DVD prohibits changing the angles. Tuner Severe hum or noise/stations cannot be received. ("TUNED" or "STEREO" flashes in the display) • Set the proper band and frequency (page 25). • Connect the antenna properly (page 8). • Find a place and an orientation that provide good reception, then set up the antenna again. If you cannot obtain good reception, we recommend you connect a commercially available external antenna. • The supplied FM lead antenna receives signals along its entire length, so make sure you extend it fully. • Locate the antennas as far away from the speaker cords as possible. • Consult your nearest Sony dealer if the supplied AM antenna has come off the plastic stand. • Try turning off surrounding electrical equipment. A stereo FM program cannot be received in stereo. • Press FM MODE repeatedly until "MONO" disappears. The tape does not record. • No cassette is loaded. Load a cassette. • The tab has been removed from the cassette. Cover the broken tab with adhesive tape (page 46). • The tape has wound to the end. • Set "Dolby Digital" or "DTS" under "AV" to "PCM". "TAPE ERR" appears in the display. • Press ?/1 to turn off the system and remove any tapes from the cassette holder. Then disconnect the power cord and reconnect it. Then press ?/1 to turn on the system. If "TAPE ERR" still appears, consult your nearest Sony dealer. Optional components There is no sound. • Refer to General item "There is no sound." (page 40) and check the condition of the system. • Connect the component properly (page 37) while checking: - if the cords are connected properly. - if the cord plugs are firmly inserted all the way. • Turn on the connected component. • Refer to the operating instructions supplied with the connected component and start playing. Tape deck The tape does not record or play, or there is a decrease in sound level. • The heads are dirty. Clean them (page 46). • The record/playback heads are magnetized. Demagnetize them (page 46). The tape does not erase completely. • The record/playback heads are magnetized. Demagnetize them (page 46). There is excessive wow or flutter, or the sound drops out. • The capstans or pinch rollers are dirty. Clean them (page 46). Noise increases or the high frequencies are erased. • The record/playback heads are magnetized. Demagnetize them (page 46). Troubleshooting continued 43GB