Sony CPD-200GS Operating Instructions - Page 6
Selecting the On-screen Display, Language, Setup - monitor manual
View all Sony CPD-200GS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Getting Started Setup Before using this monitor, check that the following items are included in your carton: • Monitor (1) • Power cord (1) • Macintosh adapter (1) • Windows® 95 Monitor Information Disk and its manual (1) • Warranty card (1) • These operating instructions (1) • Audio miniplug cord (1) This monitor works with any IBM or compatible system equipped with VGA or greater graphics capability. Although this monitor works with other platforms running at horizontal frequencies between 30 and 70 kHz (CPD100GS), 30 and 85 kHz (CPD-200GS), including Macintosh and Power Macintosh systems, a cable adapter is required. Please consult your dealer for advice on which adapter is suitable for your needs. Step 1: Connect the monitor to the computer Connecting to an IBM PC/AT, Macintosh or compatible computer With the computer switched off, connect the video signal cable to the computer's video output. IBM PC/AT or compatible computer to video output Macintosh or compatible computer to video output Macintosh adapter (supplied) 6 About the supplied Macintosh adapter The supplied Macintosh adapter is compatible with Macintosh LC, Performa, Quadra and Power Macintosh series computers. Macintosh II series and some older versions of Power Book models may need an adapter with micro switches (not supplied). Note Do not short the pins of the video signal cable. Step 2: Connect the power cord With the monitor switched off, connect one end of the power cord to the monitor and the other end to a power outlet. to a power outlet to AC IN Power cord (supplied) Step 3: Turn on the monitor and computer The installation of your monitor is complete. Note If "OUT OF SCAN RANGE" or "NO INPUT SIGNAL" appears on the screen, see "Warning Messages" on page 18. For customers using Windows 95 Install the new model information from the "Windows 95 Monitor Information Disk" into your PC. (Refer to the attached Windows 95 Monitor Information Disk manual.) This monitor complies with the "VESA DDC" Plug&Play standard. If your PC/graphics board complies with DDC, select "Plug and Play Monitor (VESA DDC)" as "Monitor type" from "Control Panel" in Windows 95. Some PCs/graphics boards do not comply with DDC. Even if your computer complies with DDC, it may have some problems connecting with this monitor. In this case, select this monitor's model name (CPD-100GS or CPD-200GS) as "Monitor type" in Windows 95. Selecting the On-screen Display Language If you need to change the OSD language, see "Selecting the on-screen display language" on page 15. The default setting is English.