Sony DCR-PC100 Operating Instructions - Page 63
To change the insert end point, Using the Remote Commander, When the inserted picture is played back
View all Sony DCR-PC100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Editing Inserting a scene from a VCR - Insert editing To change the insert end point Press ZERO SET MEMORY on the Remote Commander again after step 5 to erase the ZERO SET MEMORY indicator and begin from step 3. Using the Remote Commander In step 5, press zREC and MARK simultaneously, then immediately press X. And in step 6, press X at the scene where you want to start recording from. Note The picture and sound recorded on the portion between the insert start and end points will be erased when you insert the new scene. If you insert scenes on the tape recorded with other camcorder (including other DCR-PC100) The picture and sound may be distorted. We recommend that you insert scenes on a tape recorded with your camcorder. When the inserted picture is played back The picture and sound may be distorted at the end of the inserted portion. This is not a malfunction. The picture and sound at the start point and the end point may be distorted in the LP mode. To insert a scene without setting the insert end point Skip steps 3 and 4. Press x when you want to stop inserting. 63