Sony DCR-PC100 Operating Instructions - Page 67
To add new sound more precisely, On blank portions
View all Sony DCR-PC100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Editing Audio dubbing Notes •New sound cannot be recorded on a tape already recorded in the 16-bit mode (32 kHz, 44.1 kHz or 48 kHz) (p. 80). •New sound cannot be recorded on a tape already recorded in the LP mode. •You cannot add audio with the DV IN/OUT jack. If you make all the connections The audio input to be recorded will take precedence over others in the following order. •MIC (PLUG IN POWER) jack •Intelligent accessory shoe •AUDIO/VIDEO jack •Built-in microphone If an i.LINK cable (DV connecting cable) (not supplied) is connected to your camcorder You cannot add a sound to a recorded tape. If you set the write-protect tab of the tape to lock You cannot record on a tape. Slide the write-protect tab to release the write protection. We recommend that you add new sound on a tape recorded with your camcorder If you add new sound on a tape recorded with another camcorder (including other DCR-PC100), the sound quality may become worse. To add new sound more precisely Press ZERO SET MEMORY on the Remote Commander at the point where you want to stop recording later in the playback mode. Carry out steps 3 to 5. Recording automatically stops at the point where ZERO SET MEMORY was pressed. On blank portions You cannot add an audio. 67