Sony DCR-TRV140 Operating Instructions - Page 116
Types of trouble and their solutions, Others - driver software
UPC - 027242600263
View all Sony DCR-TRV140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
Types of trouble and their solutions Others Symptom Easy Dubbing does not function.*1) Digital program editing does not function.*2) You cannot install the USB driver.*3) USB Streaming function does not work.*3) The Remote Commander supplied with your camcorder does not work.*4) Cause and/or Corrective Actions • Your VCR and/or video camera recorder is not set correctly. c Make sure the input selector of the VCR is set to LINE. Also,make sure the power switch of the video camera is set to VTR/VCR. (p. 76) • The IR SETUP code or PAUSE MODE is not set correctly. c Select the correct IR SETUP code and PAUSE MODE, according to your VCR. Then confirm VCR operation with the IR TEST function. (p. 76) • The input selector on the VCR is not set correctly. c Set the selector correctly, and check the connection between the VCR and your camcorder. (p. 83) • The camcorder is connected to DV equipment other than of Sony using the i.LINK cable (DV connecting cable). c Keep the connection, and follow the procedure on page 87. • Setting program on a blank portion of the tape is attempted. c Set the program again on a recorded portion. (p. 91) • The synchronization of your camcorder and the VCR is not adjusted. c Adjust the synchronization of the VCR. (p. 88) • Your camcorder was connected to your computer with the USB cable before installing the USB driver, so the driver was not recognized by the computer. c Uninstall the unrecognized driver, and then reinstall the driver. (p. 99) • The USB driver is not installed correctly. c Uninstall the unrecognized driver, and then reinstall the driver. (p. 99) • Your computer's operating system is Windows 98 or earlier. • The USB cable was not connected before starting up the application software. c Connect the USB cable before starting up the application software. (p. 101) • COMMANDER is set to OFF in the menu settings. c Set it to ON. (p. 112) • Something is blocking the infrared rays. c Remove the obstacle. • The batteries are inserted in the battery holder with the + - polarities incorrectly matching the + - marks. c Insert the batteries with the correct polarity. (p. 141) • The batteries are dead. c Insert new ones. (p. 141) 116