Sony DSCS75 Operating Instructions - Page 87

Symptom The image does not appear on the TV screen. A file error occurs when you play back a file. The picture is monochrome (black and white). The lens does not retract even when the power is turned off. Your personal computer does not recognize your camera. No function works though the power is on. Cause and/or Solution • The video output signal setting of your camera is incorrect. t Change the setting (page 77). • The image size is larger than 2048×1536. t Use an image size of 2048×1536 or smaller. • The camera is set to TEXT mode. t Cancel TEXT mode (page 55). • P. EFFECT is set to B&W mode. t Cancel B&W mode (page 61). • The battery is discharged. t Replace it with a fully charged battery or use the AC power adaptor. • The battery level is low. t Use the AC power adaptor (page 14). • The camera is turned off. t Turn on the camera. • The USB cable is not connected firmly. t Disconnect the USB cable, and connect it again firmly. Make sure that "USB MODE" is displayed on the LCD screen (pages 33, 35). • The USB connectors on your personal computer are connected to other equipment besides the keyboard, the mouse, and your camera. t Disconnect the USB cables except for the ones connected to the keyboard, the mouse, and your camera. • The USB driver is not installed. t Install the USB driver (page 33). • [USB CONNECT] is set to [PTP] in the setup settings. t Set it to [NORMAL] (page 77). • Since the camera is connected to a computer with the USB cable before installing the USB driver, the drive is not recognized by the computer. t Delete the drive which is not recognized, then install the USB driver. For details, see the procedure on page 88. t Remove the battery pack, then install it again after about one minute. If the function still do not work, press the reset button located on the bottom using a sharp-pointed object. (If you press the reset button, the date and time setting is cleared.) Additional information 87