Sony EVID70/W Technical Manual - Page 11
Auto ICR Mode, Camera ID, Effect, Others, When Auto Slow Shutter is ON PRESLOW mode
View all Sony EVID70/W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Basic Functions Auto ICR Mode Auto ICR Mode automatically switches the settings needed for attaching or removing the IR Cut Filter. With a set level of darkness, the IR Cut Filter is automatically disabled (ICR ON), and the infrared sensitivity is increased. With a set level of brightness, the IR Cut Filter is automatically enabled (ICR OFF). Also on systems equipped with an IR light, the internal data of the camera is used to make the proper decisions to avoid malfunctions. When Auto Slow Shutter is OFF (PRESLOW mode ON (default) or OFF) ICR ON (Iris Open) (Gain Max) AGC MAX IRIS OPEN ICR ON GAIN IRIS Note When in Auto_ICR_OFF state and WB data is added (default), a malfunction may occur when the subjects largely consisting of blue and green colors are taken. Auto ICR is available in AE-full-auto state only. Camera ID The ID can be set up to 65,536 (0000 to FFFF). As this will be memorized in the nonvolatile memory inside the camera, data will be saved, regardless of the "position preset." Effect It consists of the following functions. • Neg. Art: Negative/Positive Reversal • Black White: Monochrome Image Dark Adjustable SHUTTER ICR ON t OFF Adjustable (Iris Min) (0dB) (1/60 sec) Bright When Auto Slow Shutter is ON (PRESLOW mode OFF) (Iris Open) (Gain Max) ICR ON AGC IRIS OPEN MAX ICR ON GAIN IRIS (Slow Shutter Max) Dark Adjustable SHUTTER ICR ON t OFF Adjustable (Iris Min) (0dB) (1/60 sec) Bright When Auto Slow Shutter is ON (PRESLOW mode ON (default)) ICR ON (Iris Open) (Gain Max) AGC MAX IRIS OPEN ICR ON GAIN IRIS (Slow Shutter Max) Dark Adjustable SHUTTER ICR ON t OFF Adjustable (Iris Min) (0dB) (1/60 sec) Bright Others IMAGE FLIP The image output by the camera is flipped upside down, and the direction of Pan/Tilt movements are reversed using the IMAGE FLIP switch on the back of the unit. Mirror Image This function reverses the video output from the camera horizontally. Freeze This function captures an image in the field memory of the camera so that this image can be output continuously. Because communication inside the camera is based on V cycle, the captured image is always the one 3V to 4Vs after the sending of a Command. Thus, you can not specify a time period after sending EVEN, ODD or a Command. Power On/Off Powers the camera on and off. When the power is off, the camera is able to accept only the lowest level of VISCA Commands and POWER of the Remote Commander; the display and other features are turned off. I/F clear Clears the Command buffer of the camera. Clearing the buffer can also be carried out from the control application software when the power is on. Address set VISCA is a protocol, which normally can support a daisy chain of up to seven attached devices. Therefore, whenever a camera is connected for the first time, be sure to use the address set to confirm the address. 11