Sony EVID70/W Technical Manual - Page 5
Locations of Controls - controller
View all Sony EVID70/W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Locations of Controls Locations of Controls Main Unit Front 12 Rear 34 56 7 8 Bottom qf qg 9 q; qa qs qd 1 Lens A wide conversion lens can be attached. 2 Sensor for the Remote Commander 3 POWER lamp 4 STANDBY lamp 5 Sensor for the Remote Commander 6 IMAGE FLIP switch Flips the image upside down and executes Pan/Tilt movement according to the camera installation. Normally set this to OFF when you use the camera. When the camera is attached to the ceiling, set this to ON. To change the mode, move the switch while the power qh is off (including standby mode). Then turn on the power using DC power, VISCA command, or the Remote Commander. After the mode has been changed, the pre-set setting saved by the Position Preset is returned to the initial setting. It takes about 7 seconds for the image to be displayed after Pan/Tilt initialization motion has stopped. Do not turn off DC power until the image has been displayed. When the power is on, you cannot flip the image using this switch. (Continued) 5