Sony FWD-42PX2 Operating Instructions (Large File - 12.86 MB) - Page 58

Location and Function of Parts and Controls Indicator Section Control Button Section (Top) 12 12345 6 1 Remote control detector Receives the signals from the Remote Commander. 2 POWER/STANDBY indicator Lights up in green when the display unit is powered on. Lights up in red in the standby mode. Lights up in orange when the display enters the power saving mode while a signal is input from a computer. When two pictures are displayed at the same time with the PICTURE AND PICTURE function, while switching the screen to normal, P&P, or PinP, the indicator blinks green to show the switching. For more details on the PICTURE AND PICTURE function, see "Viewing two pictures at the same time" on page 32 (GB). When the POWER/STANDBY indicator blinks red, see "Self-diagnosis Function" on page 43 (GB). 1 INPUT button Press to select a signal to be input from the INPUT or OPTION connector. The signal to be input switches as follows each time you press the INPUT button. When an option adaptor is not installed in the OPTION slot, OPTION will be skipped. 2 MENU button Press to show menus. Press again to hide them. 3 4 m/M (cursor/volume) button Press to move the cursor (yellow), set a value, or control speaker volume. 5 ENTER button Press to set your choice. 6 1POWER switch Press to power on the display unit. Press again to return to the standby mode. Note To protect the panel, a certain amount of time is required to turn the unit ON/STANDBY. Wait about 8 seconds after one of these operations before executing the next operation. 8 (GB)