Sony HCD-CZ1 NASCZ1 Instructions (main component system) - Page 33

Messages If a message appears while using the system, follow the procedures below to correct the problem. Network Cannot Play • The track cannot be played in the following cases: - Sampling Rate is other than 32 kHz, 44.1 kHz, 48 kHz. - The track is not being streamed by linear PCM. - The track is other than one channel or two channel. - The track sampling bits are other than 16 bits. - The server status is busy. Check Network • Check that the Ethernet cable between the system and the hub or router is firmly connected. • Check that the hub or router is turned on. IP Conflict • Set the IP addresses of the system and other devices on the network so that there is no duplication (page 20). No album • Register the track as instructed by the operation manual of the connected server. • Follow the procedure below and reconnect to the server. 1. Select "MEDIA SERVERS?" in the network menu (page 19), then press ENTER. 2. Press ./> repeatedly to select the desired media server, then press ENTER. No Server • Start up the server. M-crew Server can be started up by the following method: Right-click the task tray icon, then click "Start Music Service" in the menu. • M-crew Server may not be recognizing the system. Follow the procedure below and check whether M-crew Server is recognizing the system: 1. Click [Start] - [All Programs] - [M-crew Server] - [TOOLS] - [EQUIPMENT LIST] in that order. 2. If the system is not present in the list that appears in step 1, device registration must be performed. For details, see the Help or Install Manual within M-crew Server. • When setting a firewall other than that provided with the OS, refer to Troubleshooting in the Installation Manual included on the supplied CD-ROM. • Perform the TCP/IP settings correctly for the system and the computer (page 20). Select Server • Follow the procedure below and reconnect to the server. 1. Select "MEDIA SERVERS?" in the network menu (page 19), then press ENTER. 2. Press ./> repeatedly to select the desired media server, then press ENTER. Server Error • Follow the procedure below and reconnect to the server. 1. Select "MEDIA SERVERS?" in the network menu (page 19), then press ENTER. 2. Press ./> repeatedly to select the desired media server, then press ENTER. Server Close • Start up the server. M-crew Server can be started up by the following method: Right-click the task tray icon, then click "Start Music Service" in the menu. • When you want to change the computer's network settings, restart the server on this system. This message disappears after a short time. WebRadio Error • Register a station that can be played back on Mcrew Server. • Connection may be difficult depending on the internet line status. Wait a bit and then perform the operation again. CD/MP3 No Disc • There is no disc in the player. Troubleshooting 33GB