Sony HCD-EC619iP Operating Instructions - Page 26

Tuner, To reset the system to factory, settings

Page 26 highlights

Transferring results in an error.  Check the information on websites for compatible USB devices using the URLs listed under "USB devices" in "Compatible devices with this system" (page 23).  The USB device is not formatted correctly. Refer to the operating instructions of the USB device on how to format.  Turn off the system and remove the USB device. If the USB device has a power switch, turn the USB device off and then on again after removing it from the system. Then perform transferring again.  The USB device was disconnected or the power was turned off during transferring. Delete the partially transferred file, and perform transferring again. If this does not fix the problem, the USB device may be broken. Refer to the operating instructions of the USB device on how to deal with this problem. Audio files or folders on the USB device cannot be erased.  Check if the USB device is writeprotected.  The USB device was disconnected or the power was turned off during the erase operation. Delete the partially-erased file. If this does not fix the problem, the USB device may be broken. Refer to operating instructions of the USB device on how to deal with this problem. Play does not start.  Turn off the system and reconnect the USB device, then turn on the system.  Check the information on websites for compatible USB devices using the URLs listed under "USB devices" in "Compatible devices with this system" (page 23).  Press  to start playback. Play does not start from the first track.  Set the play mode to normal play mode. Files cannot be played back.  The audio files may have inappropriate file extensions. The file extensions supported by this system are as follows: MP3: file extension ".mp3" WMA: file extension ".wma"  USB storage devices formatted with file systems other than FAT16 or FAT32 are unsupported.*  If you use a partitioned USB storage device, only files on the first partition can be played.  Files that are encrypted or protected by passwords, etc. cannot be played back. * This system supports FAT16 and FAT32, but some USB storage devices may not support all of these FAT. For details, see the operation manual of each USB storage device or contact the manufacturer. Tuner Severe hum or noise, or stations cannot be received.  Connect the antenna properly.  Try another place and orientation for better antenna reception.  Keep the antenna away from the speaker cords and the power cord to avoid picking up noise.  Turn off nearby electrical equipment. To reset the system to factory settings If the system still does not operate properly, reset the system to factory settings. 1 Disconnect and reconnect the power cord, and then turn on the system. 2 Hold down  and EQ on the unit until "RESET OK" appears. All user-configured settings, such as preset radio stations, timer, and the clock, are deleted. 26GB

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

26
GB
Transferring results in an error.
Check the information on websites
for compatible USB devices using
the URLs listed under “USB devices”
in “Compatible devices with this
system” (page 23).
The USB device is not formatted
correctly. Refer to the operating
instructions of the USB device on
how to format.
Turn off the system and remove the
USB device. If the USB device has a
power switch, turn the USB device
off and then on again after removing
it from the system. Then perform
transferring again.
The USB device was disconnected
or the power was turned off during
transferring. Delete the partially
transferred file, and perform
transferring again. If this does not
fix the problem, the USB device may
be broken. Refer to the operating
instructions of the USB device on
how to deal with this problem.
Audio files or folders on the USB device
cannot be erased.
Check if the USB device is write-
protected.
The USB device was disconnected
or the power was turned off during
the erase operation. Delete the
partially-erased file. If this does
not fix the problem, the USB device
may be broken. Refer to operating
instructions of the USB device on
how to deal with this problem.
Play does not start.
Turn off the system and reconnect
the USB device, then turn on the
system.
Check the information on websites
for compatible USB devices using
the URLs listed under “USB devices“
in “Compatible devices with this
system” (page 23).
Press
to start playback.
Play does not start from the first track.
Set the play mode to normal play
mode.
Files cannot be played back.
The audio files may have
inappropriate file extensions. The file
extensions supported by this system
are as follows:
MP3: file extension “.mp3”
WMA: file extension “.wma”
USB storage devices formatted with
file systems other than FAT16 or
FAT32 are unsupported.*
If you use a partitioned USB storage
device, only files on the first partition
can be played.
Files that are encrypted or protected
by passwords, etc. cannot be played
back.
* This system supports FAT16 and FAT32,
but some USB storage devices may not
support all of these FAT. For details, see
the operation manual of each USB storage
device or contact the manufacturer.
Tuner
Severe hum or noise, or stations
cannot be received.
Connect the antenna properly.
Try another place and orientation for
better antenna reception.
Keep the antenna away from the
speaker cords and the power cord to
avoid picking up noise.
Turn off nearby electrical equipment.
To reset the system to factory
settings
If the system still does not operate
properly, reset the system to factory
settings.
1
Disconnect and reconnect the
power cord, and then turn on the
system.
2
Hold down
and EQ on the unit
until “RESET OK” appears.
All user-configured settings, such
as preset radio stations, timer, and
the clock, are deleted.