Sony HCD-GX9000 MHCGX9000 Instructions (Main Stereo System) - Page 39
Messages
View all Sony HCD-GX9000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
The tape does not record. • No tape is loaded. Load a tape. • The tab has been removed from the tape. Cover the broken tab with adhesive tape (page 41). • The tape has wound to the end. The Deck A does not playback reverse side. (MHC-GX9000/GN660 only) • The Deck A only playback front side of the tape. This is not a malfunction. If the system still does not operate properly after performing the above measures or other troubles does not described above occur, reset the system as follows: Use buttons on the system for the operation. 1 Unplug the power cord. 2 Plug the power cord back in. 3 Press ?/1 to turn on the system. 4 Press x, ENTER and ?/1 at the same time. The system is reset to the factory settings. All the setting are cleared. You should set the settings you made, such as the preset stations, clock and timer. Messages One of the following messages may appear or flash in the display during operation. CD/MP3 NO STEP You have cleared all the tracks you programmed. OVER You have reached the end of the disc while turning and holding m M clockwise (or pressing M on the remote) during playback or pause playback. No Disc There is no disc in the system. Push STOP! You pressed PLAY MODE during playback. Step Full! You tried to program more than 25 steps. Reading The system is reading information of the disc. Some buttons are not available. Tape No Tab You cannot record the tape because the tab has been removed from the tape. No Tape There is no tape in the tape deck. Timer OFF TIME NG! The on time and off time of Play Timer or Timer Recording is same. SET CLOCK! You pressed CLOCK/TIMER SELECT before the clock is set. SET TIMER! You pressed CLOCK/TIMER SELECT before Play Timer or Timer Recording is set. PUSH SELECT! You tried to set the clock or timer during timer operation. Troubleshooting 39GB