Sony HDR-PJ760V Operating Guide - Page 83
Notes on optional accessories, Active Interface Shoe, On Wireless Remote Commander, LCD screen
View all Sony HDR-PJ760V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
power of the camcorder is turned on, do not close the LCD panel. The image data that has been recorded may be lost. Insulation sheet Others/Index Notes on optional accessories We recommend using genuine Sony accessories. Genuine Sony accessories may not be available in some countries/regions. Active Interface Shoe The Active Interface Shoe supplies power to accessories such as a video light, a flash, or a microphone (sold separately). The accessory can be turned on or off as you open or close the LCD screen, and the viewfinder (HDRCX760V/PJ760/PJ760V) of your camcorder. Refer to the operating instructions supplied with your accessory for details. The Active Interface Shoe has a safety device for fixing the installed accessory securely. To connect an accessory, press down and push it to the end, and then tighten the screw. To remove an accessory, loosen the screw, and then press down and pull out the accessory. When you are recording movies with an external flash (sold separately) connected to the accessory shoe, turn off the power of the external flash to prevent charging noise being recorded. You cannot use an external flash (sold separately) and the built-in flash at the same time. When an external microphone (sold separately) is connected, it takes precedence over the builtin microphone. On Wireless Remote Commander Remove the insulation sheet before using the Wireless Remote Commander. Point the Wireless Remote Commander towards the remote sensor to operate your camcorder (p. 13). When no commands have been sent from the Wireless Remote Commander within a certain period, the light blue frame disappears. When you press any of or ENTER again, the frame appears at the position where it was displayed last. You cannot select some buttons on the LCD screen, or the viewfinder (HDR-CX760V/ PJ760/PJ760V) using To change the battery of the Wireless Remote Commander While pressing on the tab, inset your fingernail into the slit to pull out the battery case. Place a new battery with the + side facing up. Insert the battery case back into the Wireless Remote Commander until it clicks. Tab WARNING Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire. When the lithium battery becomes weak, the operating distance of the Wireless Remote Commander may shorten, or the Wireless Remote Commander may not function properly. In this case, replace the battery with a Sony CR2025 lithium battery. Use of another battery may present a risk of fire or explosion. LCD screen Do not apply excessive pressure on the LCD screen, as it may cause uneven color and other damage. US 83