Sony HT-1700D Primary User Manual - Page 4

About This Manual The instructions in this manual are for models HT-6500DP, HT-5500D and HT-1700D. Check your model number by looking at the lower right corner of the front panel. In this manual, the STR-K840P is used for illustration purpose unless stated otherwise. Any difference in operation is clearly indicated in the text, for example, "HT-6500DP only". The HT-6500DP consists of: - Receiver - Speaker system • Front/surround speakers • Center speaker • Sub woofer - DVD player STR-K840P SS-MSP2 SS-CNP2 SA-WMSP4 DVP-NC655P The HT-5500D consists of: - Receiver - Speaker system • Front/surround speakers • Center speaker • Sub woofer - DVD player STR-K840P SS-MSP2 SS-CNP2 SA-WMSP4 DVP-NC615 The HT-1700D consists of: - Receiver - Speaker system • Front/surround speakers • Center speaker • Sub woofer - DVD player STR-K740P SS-MSP2 SS-CNP2 SA-WMSP4 DVP-NS315 About area codes The area code of the receiver you purchased is shown on the lower portion of the rear panel (see the illustration below). IMPEDANCE USE 8 - 16Ω ENTER FRONT R L R L 4-XXX-XXX-XX AA Area code Any differences in operation, according to the area code, are clearly indicated in the text, for example, "Models of area code AA only". 4US Tip The instructions in this manual describe the controls on the receiver. You can also use the controls on the supplied remote if they have the same or similar names as those on the receiver. For details on the use of your remote, see pages 37 - 43 for RM-PP411 (HT-6500DP and HT-5500D only) and pages 44 - 47 for RM-U306 (HT-1700D only). For details on the use of your DVD player, refer to the separate operating instructions supplied with the DVD player. Note for the supplied remote For RM-PP411 (HT-6500DP and HT-5500D only) The VIDEO 3, TV/SAT, PHONO, AUX, SOURCE, MPX/DUAL, ANALOG DIRECT, 12 and ON SCREEN buttons on the remote are not available. For RM-U306 (HT-1700D only) The MULTI CH button on the remote is not available. Demonstration Mode The demonstration will activate the first time you turn on the power. When the demonstration starts, the following message appears in the display: "NOW DEMONSTRATION MODE IF YOU FINISH DEMONSTRATION PLEASE PRESS POWER KEY WHILE THIS MESSAGE APPEARS IN THE DISPLAY THANK YOU" To cancel the demonstration Press ?/1 to turn the receiver off while the above message is being displayed. The next time you turn the receiver on, the demonstration will not appear. To view the demonstration Hold down SET UP and press ?/1 to turn on the power. Notes • Running the demonstration will clear the receiver's memory. For details on what will be cleared, see "Clearing the receiver's memory" on page 15. • There will be no sound when the demonstration mode is activated. • You cannot cancel demonstration if you did not press ?/1 while the above message is being displayed. To cancel demonstration after the above message appears, press ?/1 twice to activate the demonstration again. Then, press ?/1 while the above message is being displayed.