Sony HVRM25AU Operating Instructions - Page 37
Connecting the unit to a monitor equipped, with an i.LINK jack
UPC - 027242746763
View all Sony HVRM25AU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Chapter 2 Playback and Recording Notes • To playback an image recorded in HDV format when you connect the monitor using an HDMI cable or a component video cable, set [HDMI/CMPNT] of [VIDEO OUT] in the [IN/OUT REC] menu according to the requirements of your monitor (page 71). • When an image recorded in DVCAM/DV format is played back, only an image with a quality equivalent to that of the DVCAM/DV format of 480i (NTSC) or 576i (PAL) is output via the COMPONENT OUT jacks, regardless of the [HDMI/CMPNT] setting. • For details on the output level from the HDMI OUT jack and the COMPONENT OUT jacks, see "Specifications" (page 100). • To change the output level from the COMPONENT OUT jacks, see [480i LEVEL] in the [IN/OUT REC] menu (page 74). • There are some restrictions on images output from the HDMI OUT jack and the COMPONENT OUT jacks of the unit. Refer to HDMI OUT jack 6 (page 17), COMPONENT OUT jacks 5 (page 17) of "Location and Function of Parts." For more information, see "Recording Format and Input/ Output Signals" on page 31. • If you connect the input connectors of the unit to the output connectors of a monitor, a humming noise may be generated or the image may be distorted. If these phenomena occur, use the INPUT SELECT switch to select a signal that is not being input, or disconnect the cables. • When you play back an HDV-formatted tape with copyright protected signals or input HDV signals with copyright protection to the HDV/DV jack, pictures may be output in either 480i (NTSC) or 576i (PAL) format, regardless of the setting of [HDMI/CMPNT] of [VIDEO OUT] in the [IN/OUT REC] menu. • The unit cannot up convert DVCAM/DV recordings to HDV at output. • When [HDMI/CMPNT] of [VIDEO OUT] in the [IN/ OUT REC] menu is set to either [1080i/480i] or [1080i/576i], 1080/24p and 1080/30p video signals played back are converted to 1080/60i and 1080/25p video signals are to 1080/50i, and output from the COMPONENT OUT jacks and the HDMI OUT jack. Connecting the unit to a monitor equipped with an i.LINK jack The video and audio signals are sent with hardly any degradation, enabling high-quality playback to a monitor with an i.LINK connector that supports HDV, DVCAM, and DV formats. For details on i.LINK output formats, see page 97. HVR-M25A (rear panel) i.LINK cable (not supplied) To i.LINK jack ( HDV/DV jack) Monitor with i.LINK jack : Signal flow Notes • Be sure that you set [HDV/DV SEL] in the [IN/OUT REC] menu to [AUTO] (default setting) before connecting the monitor to the unit with the i.LINK cable. If you change the setting after connecting the i.LINK cable, the monitor may not recognize the video signals correctly (page 70). • To connect the unit to a monitor equipped with an i.LINK jack, you may need to set the monitor so that it recognizes the unit. For details, refer to your monitor's instruction manual. • When an i.LINK connection is made, the unit cannot output video or audio only. (Continued) 37 Chapter 2 Playback and Recording