Sony LBT-D2220 Operating Instructions - Page 20
hating, aying
View all Sony LBT-D2220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
si•hating the ota aying ime 5 Press the EDITITIME FADE button once more while "B" in the tape indicator is blinking. Another program for the other side is completed. EDIT/TIME FADE O 2 3 4 5 ID• nnnign iID .... mom MN isc z ommun c a. 2 7 C"Li] m.... .um To play the program Press the►button. The selections for side A will be played and then the unit will pause "B" lights up on the tape side indicator. Set the tape to the beginning of side B, then press the 10. or the U button. The selections for side B will be played. Note Playback can be peened when "EDIT' is displayed. To add selection(s) -LINK- After all selections on the disc have been programmed, if there is selection(s) within the remaining time, "LINK" and the selection number(s) will flash. To add a selection, press the EDIT/TIME FADE button again. A program will be made automatically to fit the playing time as close as possible to the remaining time. If the remaining time can contain other selection(s). "LINK" and the selection number keep flashing. When,"LINK" flashes, if the disc is changed to another disc, the new selection number(s) on the new disc that fits in the remaining time will flash. "EDIT" disappears when the playing time becomes equal to the designated time. Whether "LINK" is blinking or not, you can change the disc to another disc and choose selection(s) to fit the remaining time. To turn off "EDIT" in the display, press the • button. To stop playing Press the I button. You can play the same program repeatedly as long as you do not cancel the edit or erase the program. To cancel the edit Press the CONTINUE button and return to continuous play mode. The program will be erased. To erase the entire program Press the • button once during stop; twice during play. The program is also erased, when you turn off the unit. To check the program See page 17. If your disc has more than 20 selections Selection over number 20 cannot be programmed with the time edit function; use the programming procedure on page 16. To designate a different time for each side Execute steps 1 to 4 on page 19, then press the II button. Then execute steps 2 to 4 for the other side. To include desired selections in the program 1 Make your own program of the desired selections. See page 16 for instructions. 2 Follow the procedure as shown on the preceding page. Just designate the length of your tape; you need not subtract the length of your program. The unit will place your selections at the beginning of its program and add other selections to fit the remaining time. 'maw 23 4 ; 1. ae, n I U 18. ti 8 L ai( A i 1 IP ap.7 V 20