Sony LSPX-P1 Reference Guide - Page 2

On placement • Do not place the unit in any places where there is excessive dust or cigarette smoke. Dust and cigarette tar adheres to components inside the unit (such as the projection window) causing a malfunction. • Do not place the unit in any places where the temperature is extremely hot or cold, or the humidity is extremely high. Especially when there is strong sunshine or during the summer, the inside of a car can get quite hot, and a unit left in the car may deform or malfunction. • Do not place the unit on an unstable surface. The unit may fall or topple over resulting in injuries. • Do not place the unit where there is water. It may cause a fire or electric shock. • Do not place/store the unit in a place exposed to direct sunlight or close to a heater. Heat may build up in the unit causing a fire. On AC adaptor and cables • Do not damage the power cord. It may cause a fire or electric shock. • Be sure to use the supplied AC adaptor with the unit. If a different AC adaptor is used with the unit, it may cause a fire, electric shock or malfunction. • Do not touch the power plug with wet hands. It may cause an electric shock. • Before making connections with the AC adaptor and connection cables, turn off the unit and connected equipment, and unplug the power plugs from the wall outlet. • Do not wrap the power cord or connection cable around the AC adaptor. It may cause the cord or cable to break. • Before moving the unit, disconnect the power cord and connection cables. The cables may be damaged resulting in a fire or electric shock, or connected equipment may fall or topple over causing injuries. • Insert the connector straight. If it is inserted at an angle, pins may make a short circuit causing a fire. On fan noise A fan is incorporated inside the projector to prevent overheating, and this makes a slight noise while turned on. This noise is not a malfunction. However, if there are any abnormal noises, consult qualified Sony personnel. On light source maintenance This unit uses a laser, therefore special caution and facilities are necessary for the inspection and maintenance of light source components. Be sure to consult qualified Sony personnel. On cleaning • Be sure to turn the unit off and unplug it from the wall outlet before cleaning. • If the unit is rubbed hard with a dirty cloth, the unit may be scratched. • If volatile liquids such as insecticide are sprinkled on the unit, or an item made of rubber or vinyl stays in physical contact with the unit for a long time, the unit may be affected or the surface color may fade. • Do not touch the projection window with bare hands. • To clean the surface of the projection window: Gently wipe it with a soft cloth such as an eyeglass cleaning cloth. If there are stubborn stains, wipe them up with a cloth moistened with water. Never use alcohol, benzene, thinner, acidic cleaning agents, alkaline cleaning agents, abrasive cleaning agents, chemical dust cloths, and so on. • To cleaning the exterior: Gently wipe it with a soft cloth. If there are stubborn stains, wipe up the stains with a soft cloth which has been soaked in diluted neutral detergent and thoroughly wrung out, then wipe the exterior again with a dry cloth. Do not use alcohol, benzene, thinner, and so on. On projector • Although this unit is manufactured using very high precision technology, there may be some permanent black or white pixels on the projected screen. Also, there may be striped unevenness in color or brightness. This is a result of the projector structure and is not a malfunction. The color balance of each projector unit varies; therefore, when multiple LCD projectors are used, the color reproduction among projectors may vary, even if they are of the same model. • Depending on viewed content, primary colors such as red, blue, or green are visible when you move your eyes or under certain conditions; this is not a malfunction. It is caused by a "color breakup" phenomenon which is specific to the field-sequential color system adopted into the unit for displaying images. This phenomenon can be subdued by diminishing the contrast between the image and the backdrop, such as decreasing the brightness of the unit or increasing the brightness of the room. On condensation If the projector is moved suddenly from a cold to a warm place, or just after a room heater is turned on in a winter morning, condensation may occur on the surface or inside of the projector. If condensation occurs, leave the projector turned off until the condensation dissipates. If the projector is used while there is condensation, it may cause a malfunction. On ventilation holes • Do not block the ventilation holes (intake/exhaust). If the ventilation holes are blocked, heat will build up inside the unit, causing a fire or malfunction. To maintain good ventilation, observe the following: - Place the unit away from walls and objects. - Do not use a cover that blocks the ventilation holes. - Do not place the unit on a soft cloth, paper documents, thick carpet or small pieces of paper. They may be drawn in and block the intake holes. • Do not bring your hand or object close to the exhaust holes. It may cause burns or deformation. On projection window • Do not look into the projection window. The light may damage your eyes. • Do not obstruct the projection window. The light will heat the obstruction, which may cause deterioration, deformation, burns or fire. Cautions about heat generation of the unit • While using or charging the unit, the unit or AC adaptor may become hot; this is not a malfunction. If the unit temperature becomes excessively hot, it may automatically turn off for safety. In such a case, use it in a cooler place after the unit has cooled down. • If the unit or AC adaptor becomes unusually hot, it may malfunction. Immediately turn the unit off and unplug the AC adaptor from the wall outlet, then consult qualified Sony personnel. • Do not continue touching the unit in operation or the AC adaptor for a long time. Prolonged contact with the skin may result in burns. Even touching through clothing, prolonged contact may result in burns. • Do not use the unit or AC adaptor covered by cloth or bedding. Heat will build up causing deformation, malfunction or a fire. On charging • Charge the unit in the ambient temperature of 5 °C to 35 °C (41 °F to 95 °F). The unit may not charge sufficiently outside this temperature range. • While charging or using the unit, the temperature of the unit may rise; this is not a malfunction. • If you do not use the unit for a long time, charge it every six months to prevent battery degradation. • When the unit has been left unused for a long time, the charging time may be longer. • When the battery usage time drops to half of its original time, it may have reached the end of its life span. Consult qualified Sony personnel about the rechargeable battery replacement. On AC power interruption When the unit is turned off using the power button, the power supply to the unit is not completely stopped. To completely stop the power supply to the unit, unplug it from the wall outlet. Place the AC adaptor close to the wall outlet so that you can quickly unplug it when becoming aware of a problem. Notes on wireless LAN Sony is not liable for any loss or damage caused by loss or theft of the unit resulting in unauthorized accesses to or abuse of the equipment which is incorporated into the unit. Notes on wireless LAN security • Always make sure that you are using a wireless LAN that is secured against hacking, access from malicious third parties, and other vulnerabilities. • Proper security setting for a wireless LAN is very important. • Sony is not liable for any loss or damage caused by security problems resulted from failing to take security countermeasures, or unavoidable circumstances due to specifications of the wireless LAN. If you have questions or problems, read this document, Startup Guide, and Help Guide (Web operating instructions) thoroughly again. If the answer is not found, consult qualified Sony personnel. Specifications Portable Ultra Short Throw Projector (LSPX-P1)  Projector Display system Projection system Display device 0.37 inch SXRD × 1 1366 × 768 pixels Projection image size 22 inches to 80 inches Light source Laser diode Light output 100 lm  Audio Speakers Approx. 25 mm diameter × 2 (monaural) bass reflex system Amplifier 2 W × 2 W monaural (4 ohms)  Wireless communication Wireless LAN IEEE 802.11a/b/g/n (2.4 GHz band, 5 GHz band), MIMO compatible Bluetooth Bluetooth 4.0 (Bluetooth Low Energy)  General Operating temperature 5 °C to 35 °C (41 °F to 95 °F) Built-in battery Lithium-ion battery Dimensions Approx. 80 mm × 131 mm × 131 mm (3 1/4 inches × 5 1/4 inches × 5 1/4 inches) (width × height × depth) Mass Approx. 930 g (2 lb 1 oz) Wireless Unit (LSPX-PT1)  Input/output HDMI IN connector HDMI OUT (pass through) connector IR BLASTER connector (Mini jack)  Wireless communication Wireless LAN IEEE 802.11a/n (5 GHz band), MIMO compatible  General Operating temperature 5 °C to 35 °C (41 °F to 95 °F) Dimensions Approx. 135 mm × 35 mm × 135 mm (5 3/8 inches × 1 7/16 inches × 5 3/8 inches) (width × height × depth) Mass Approx. 200 g (7 oz) Supplied accessories AC adaptor VGP-AC19V77 (1) AC adaptor LSPX-AC5V2 (1) Power cord (2) IR Blaster (1) Startup Guide (1) Reference Guide (this document) (1) Warranty (1) Optional accessories Floor stand LSPX-PS1 Design and specifications are subject to change without notice. • Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories. • The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries. • The BLUETOOTH SMART word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Sony Corporation is under license. • Wi-Fi, Wi-Fi Direct, Miracast, and Wi-Fi Protected Setup are trademarks or registered trademarks of Wi-Fi Alliance. • Google, Google logo, Android, Google Play, and YouTube are trademarks or registered trademarks of Google Inc. • Apple, Apple logo, iPhone, and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a service mark of Apple Inc. • All other names of systems, products, and services are trademarks or registered trademarks of their respective owners. In this manual, the ™ or ® marks are not specified. All rights which are not explicitly written in this document belong to their respective owners. (Only as for projector) Notes on Third Party Software Portable Ultra Short Throw Projector and Wireless Unit contain certain third party software which is distributed and/or made available under such terms provided by the copyright owners ("Third Party Software"). Third Party Software includes those commonly referred to as "free software" and/or "open source software". The applicable license terms for Third Party Software designated by the copyright owners are listed on the website shown below. Your use of Third Party Software is subject to the applicable license terms. http://oss.sony.net/Licence/LSPX-P1_LSPX-PT1/ Third Party Software contains GNU General Public License ("GPL") and/or GNU Lesser General Public License ("LGPL"). We inform that you have a right to have access to, modify and redistribute the source codes for Third Party Software licensed under GPL/LGPL. The source codes for GPL/LGPL applicable Third Party Software are available for downloading on the website shown below. Please access the following URL and select "LSPX-P1" or "LSPX-PT1". http://www.sony.net/Products/Linux/ Sony is not obligated to provide and does not provide any support or assistance with respect to the source codes. LSPX-P1 4-581-618-11(1)