Sony MEX-BT3000P Operating Instructions - Page 14
Connection, Connecting a cellular phone - bluetooth
View all Sony MEX-BT3000P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
The unit is ready for connection to the device. Note If " " continues to flash, the Bluetooth device may not be compatible with this unit. For details on compatible devices, visit the support site on the back cover. 5 Select this unit on the Bluetooth device to be connected. " " or " " appears when the connection is made. Notes • While connecting to a Bluetooth device, this unit cannot be detected from another device. To enable detection, enter the pairing mode and search for this unit from another device. • It may take time to search or connect. • Depending on the device, the confirmation display of the connection appears before inputting the passkey. • The time limit for inputting the passkey differs depending on the device. If the time expires, perform the pairing procedure from the beginning again. • This unit cannot be connected to a device that supports only HSP (Head Set Profile). Tip Connection between this unit and the Bluetooth device may be automatic, depending on the device. Cancelling pairing Perform step 2 to cancel the pairing mode after this unit and the Bluetooth device are paired. Connection To use the device after pairing is made, start the connection. Sometimes pairing allows for connection automatically. If pairing has already been achieved, start operation from here. Connecting a cellular phone 1 Press and rotate the control dial until "SET BT SIGNL" appears, then press it. " " lights up when Bluetooth signal is activated. Note When the Bluetooth signal for this unit is already ON, selecting "SET BT SIGNL" deactivates the Bluetooth signal. Tip You can also output the Bluetooth signal from this unit by pressing and holding on this unit more than two seconds. 2 Turn on the cellular phone and activate the Bluetooth signal. 3 Connect to this unit using the cellular phone. " " appears when the connection is made. If you select the Bluetooth Phone source after the connection is made, the network name and the connected 14