Sony MEX-DV1700U Installation/Connections - Page 2

Foot brake type Parking brake switch cord Hand brake type Parking brake switch cord 1   2  Face the hook inwards.    A Front panel release button B  1  2 Claws 3 Dashboard   Fire wall   A TOYOTA  size 5 × max. 8 mm (7/32 × max. 5/16 in) to dashboard/center console B NISSAN  size 5 × max. 8 mm (7/32 × max. 5/16 in) to dashboard/center console Bracket Bracket Existing parts supplied with your car  size 5 × max. 8 mm (7/32 × max. 5/16 in) Bracket Bracket Existing parts supplied with your car  size 5 × max. 8 mm (7/32 × max. 5/16 in) Precautions  Choose the installation location carefully so that the unit will not interfere with normal driving operations.  Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperatures, such as in direct sunlight or near heater ducts.  Use only the supplied mounting hardware for a safe and secure installation. Mounting angle adjustment Adjust the mounting angle to less than 45°. Connecting the parking brake cord Be sure to connect the parking cord (Light green) of  to the parking brake switch cord. The mounting position of the parking brake switch cord depends on your car. Consult your car dealer or your nearest Sony dealer for further details. Removing the protection collar and the bracket Before installing the unit, remove the protection collar  and the bracket  from the unit. 1 Remove the protection collar . Pinch both edges of the protection collar , then pull it out. 2 Remove the bracket .  Insert both release keys  together between the unit and the bracket  until they click.  Pull down the bracket , then pull up the unit to separate. Mounting example Installation in the dashboard Notes  Bend these claws outward for a tight fit, if necessary (-2).  Make sure that the 4 catches on the protection collar  are properly engaged in the slots of the unit (-3). How to detach and attach the front panel Before installing the unit, detach the front panel. -A To detach Before detaching the front panel, be sure to press and hold Press the front panel release button, and pull it off towards you. -B To attach Engage part  of the front panel with part  of the unit, as illustrated, and push the left side into position until it clicks. Warning if your car's ignition has no ACC position Be sure to set the Auto Off function. For details, see the supplied Operating Instructions. The unit will shut off completely and automatically in the set time after the unit is turned off, which prevents battery drain. If you do not set the Auto Off function, press and hold until the display disappears each time you turn the ignition off. Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer. Fuse (10 A) Mounting the unit in a Japanese car You may not be able to install this unit in some makes of Japanese cars. In such a case, consult your Sony dealer. Note To prevent malfunction, install only with the supplied screws .