Sony MEX-DV1700U Operating Instructions - Page 12
Getting Started, Performing initial setup, Detaching the front panel - car audio
View all Sony MEX-DV1700U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Getting Started Performing initial setup When you first turn on the unit after purchasing it, the display for initial speaker setup appears. Detaching the front panel You can detach the front panel of this unit to prevent theft. 1 Press and hold The unit is turned off. 2 Press the front panel release button , then pull it off towards you. Be sure to set correctly following the procedure below to enjoy the various sound functions of this unit. To skip the initial setup, press or insert a disc. 1 Press the control dial in the initial setup display. 2 Rotate the control dial to set the audio output, then press it. If a subwoofer is connected, select "SUB OUT." If a power amplifier is connected, select "REAR OUT." If neither subwoofer or power amplifier is connected, you can select either "SUB OUT" or "REAR OUT." 3 Rotate the control dial to select your listening position, then press it. Select "FRONT L" if your listening position is front left, or select "FRONT R" if front right. The clock display appears when the setting is complete. With the card remote commander Press / instead of rotating the control dial, press instead of pressing the control dial. Caution alarm If you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the built-in amplifier is used. Note Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray. Attaching the front panel Engage part of the front panel with part of the unit, as illustrated, and push the left side into position until it clicks. 12