Sony MHC-DP1000D Operating Instructions - Page 12
Inserting two size AA (R6) batteries into the remote, Hooking up the system continued
View all Sony MHC-DP1000D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Hooking up the system (continued) 8 (Except for Pan American and European models) Set the color system according to your TV. The color system is factory set to NTSC for region code 3 models, and PAL for other region code models. Each time you perform the procedure below, the color system changes as follows: NTSC y PAL Use the buttons on the unit. 1 Press ?/1 to turn on the system. 2 Press DVD. 3 Press x. 4 Press ?/1 while holding down X. The system turns off. 5 Press ?/1 to turn on the system. The system turns on and the color system is changed. To attach the speaker pads Attach the supplied speaker pads to the bottom of the speakers to stabilize the speakers and prevent them from slipping. Notes • Keep the speaker cords away from the antennas to prevent noise. • The type of speakers supplied vary according to the model you purchased (see "Specifications" on page 59). • Do not place the rear speakers on top of a TV. This may cause color distortion in the TV screen. • For MHC-DP1000D, be sure to connect both left and right rear speakers. Otherwise, the sound will not be heard. • When you play a VIDEO CD recorded in the different color system from the one you set to the system, the picture image may be distorted. Inserting two size AA (R6) batteries into the remote ] } } ] Operating a Sony TV You can use the following buttons on the remote to operate a Sony TV. To Turn the TV on or off Switch the TV's video input Change the TV channels Adjusts the volume of the TV speaker(s) Press TV ?/1. TV/VIDEO. TV CH +/-. TV VOL +/-. Tip When the remote no longer operates the system, replace both batteries with new ones. Note If you do not use the remote for a long period of time, remove the batteries to avoid possible damage from battery leakage. Notice for carrying this system Do the following to protect the DVD mechanism. 1 Turn on the system, then press DVD. Make sure that all discs are removed from the unit. 2 Hold down DVD, then press ?/1 until "LOCK" appears. 3 Release ?/1 first, then release DVD. 4 Unplug the AC power cord. 12