Sony MHC-V5 Operating Instructions - Page 47

ˎˎ(USA model only) One blade of the plug is wider than other for the purpose of safety and will fit to the wall outlet only one way. If you are unable to insert the plug fully into the outlet, contact your dealer. ˎˎAC power cord must be changed only at the qualified service shop. On placement ˎˎDo not place the system in an inclined position or in locations that are extremely hot, cold, dusty, dirty, or humid or lacking adequate ventilation, or subject to vibration, direct sunlight or a bright light. ˎˎBe careful when placing the system on surfaces that have been specially treated (for example, wax, oil, polish) as staining or discoloration of the surface may result. ˎˎIf the system is brought directly from a cold to a warm location or is placed in a very damp room, moisture may condense on the lens inside the unit, and cause the system to malfunction. In this situation, remove the disc, and leave the system turned on for about an hour until the moisture evaporates. On heat buildup ˎˎHeat buildup on the unit during operation is normal and is not a cause for alarm. ˎˎDo not touch the cabinet if it has been used continuously at a high volume because the cabinet may have become hot. ˎˎDo not obstruct the ventilation holes. On the speaker system The built-in speaker system is not magnetically shielded, and the picture on nearby TV sets may become magnetically distorted. In this situation, turn off the TV, wait 15 to 30 minutes, and turn it back on. If there is no improvement, move the system far away from the TV. Cleaning the cabinet Clean this system with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as thinner, benzine, or alcohol. On BLUETOOTH Communication ˎˎBLUETOOTH devices should be used within approximately 10 meters (33 feet) (unobstructed distance) of each other. The effective communication range may become shorter under the following conditions. ˋˋ When a person, metal object, wall or other obstruction is between the devices with a BLUETOOTH connection ˋˋ Locations where a wireless LAN is installed ˋˋ Around microwave ovens that are in use ˋˋ Locations where other electromagnetic waves occur ˎˎBLUETOOTH devices and wireless LAN (IEEE 802.11b/g) use the same frequency band (2.4 GHz). When using your BLUETOOTH device near a device with wireless LAN capability, electromagnetic interference may occur. This could result in lower data transfer rates, noise, or inability to connect. If this happens, try the following remedies: ˋˋ Try connecting this system and BLUETOOTH device when you are at least 10 meters (33 feet) away from the wireless LAN equipment. ˋˋ Turn off the power to the wireless LAN equipment when using your BLUETOOTH device within 10 meters (33 feet). ˎˎThe radio waves broadcast by this system may interfere with the operation of some medical devices. Since this interference may result in malfunction, always turn off the power on this system and BLUETOOTH device in the following locations: ˋˋ In hospitals, on trains, in airplanes, at gas stations, and any place where flammable gases may be present ˋˋ Near automatic doors or fire alarms 47GB Additional Information