Sony MZ-N10 Operating Instructions (primary manual) - Page 90
Messages, Error message, Meaning/Remedy
View all Sony MZ-N10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Messages If the following error messages flash in the display window, check the chart below. Error message Meaning/Remedy FULL • You tried to set a 21st bookmark. , You can set only up to 20 bookmarks. Keep the number of bookmarks within 20. AVLS BLANKDISC • AVLS is set to "AVLS ON" and so the volume cannot rise higher. , Set AVLS to "AVLS OFF" (page 68). • An MD with no recording on it is inserted. BUSY • You tried to operate the recorder while it was accessing the recorded data. , Wait until the message goes out (in rare cases, it may take a few minutes). CannotCHG • You tried to charge the battery at a place with a temperature outside the specified range for the recorder. , Charge the battery at a temperature of 0° C (+32° F) to +40° C (+104° F). Charging • The internal battery is being charged. DISC FULL ERROR • The remaining recording time on the disc is 12 seconds (SP stereo), 24 seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less. , Replace the disc. • There is an internal malfunction in the system. , Restart the operation by doing steps 1 to 3 on page 89. If the message appears again, please consult your nearest Sony dealer. GroupFULL • You tried to create a 100th group. , You can create only up to 99 groups on a disc. Keep the group number within 99. Hi DC in • Voltage of the power supply is too high (The supplied AC power adaptor or the recommended car battery cord is not used). , Use the supplied AC power adaptor or the recommended car battery cord. HOLD LINE OUT • The recorder is locked. , Slide HOLD against the arrow to unlock the recorder (page 20). • You pressed VOL+, - while the "AUDIO OUT" parameter was set to "LINE OUT". , Use the jog dial to set the "AUDIO OUT" parameter to "HeadPhone". 90