Sony PSLX250H Operating Instructions - Page 4

Getting Started Assembling the Turntable 5 3 2 4 1 Installing the dust cover Insert the hinges on the dust cover into the hinge pockets on the rear of the cabinet. 1 Set the EQ switch according to the jacks of your stereo system (amplifier). • When your stereo system (amplifier) has PHONO input jacks (connect to PHONO input jacks) nset to OFF. • When your stereo system (amplifier) does not have PHONO input jacks (connect to AUX, VIDEO input jacks, etc.) nset to ON. ON OFF 2 Move the metallic parts inside the larger gear in the direction of arrows. When the power is supplied after assembling or moving the turntable The turntable sometimes rotates and the torn arm descends to the platter even if START is not pressed. If this occurs, press STOP to return the tone arm to the arm stand. 3 Carefully, place the platter on the spindle. 4 Using the ribbon, loop the drive belt around the motor pully. After looping the belt, do not forget to remove the ribbon. Hooking up the Turntable The phono cables come attached to the rear of the cabinet. 1 Connect the cable with the white plug to the white (L) jack and connect the cable with the red plug to the red (R) jack. Make sure to insert the plugs firmly into the jacks. If the plugs are not inserted firmly, noise may be occured. Amplifier L PHONO IN L R R It is necessary to set the EQ switch according to the connected jacks. For details, refer to step 1 in "Assembling the Turntable". Mains lead hookups Connect the mains lead to an AC wall outlet after completing all of the previous connections. / to a wall outlet 5 Place the rubber mat on the platter. 4GB