Sony RM-AV2100B Operating Instructions (primary manual) - Page 29
While pressing COMMANDER, OFF, press VOLUME+ and VCR3., While pressing the RESET key, press VCR3.
View all Sony RM-AV2100B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Notes • You can program the System Control functions for a Component Select button on which the Power-On function (page 31) has been programmed. In this case, the Power-On function is overwritten and cannot be used. If you clear the System Control functions for the button, the Power-On function is resumed, and you can use it again. • You cannot program the System Control functions for a Component Select button for which a signal has been programmed by "learning" (page 32). ("NG" flashes on the display.) • You can program a signal for a Component Select button by "learning" (page 32) for which the System Control functions have been programmed. In this case, the System Control function is overwritten and cannot be used. If you clear the "learned" signal on the button, the System Control function is resumed and you can use it again. • You can program the Power-On function (page 31) for a Component Select button for which a System Control function has been programmed, but the Power-On function cannot be used. If you clear the System Control function from the button, you can use the Power-On function. • If you interrupt the procedure at any point for over two minutes, the setting mode ends and the series of commands will be programmed to that point. In this case, clear the program and start again from Step 1 to set the entire program from the beginning. You can not continue from where you let off. •If you change the component code number (page 8) or program a new signal by learning (page 16) for a key or button that has been programmed with the series of commands of a System Control function, the new signal will be transmitted when you press the corresponding Component Select button. To clear a System Control function programmed for a Components Select buttons Example: To clear the programmed commands on the VCR3 button 1 While pressing COMMANDER OFF, press VOLUME+ and VCR3. 2 While pressing the RESET key, press VCR3. When the contents of its program are cleared, all the component names flash. When you want to set a new program to this Component Select button, follow Steps 1 to 2 on page 28. Continued 29