Sony RM-AX4000 Operating Instructions - Page 19
Connecting the Remote Commander to your PC - universal remote
UPC - 027242677036
View all Sony RM-AX4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Connecting the Remote Commander to your PC You can now connect the Remote Commander to your PC with the supplied USB cable. Connect whenever you want to verify correct operation of key/button commands for an XPRESS function, etc., or to exchange setup data between your PC and the Remote Commander. IMPORTANT Do not keep the Remote Commander connected to the PC when the PC is in standby/hibernation, otherwise, a malfunction could occur. Be sure to disconnect the Remote Commander from the PC before standby/hibernation begins. Furthermore, do not connect the Remote Commander to the PC while it is in standby/ hibernation. Wait until the PC comes out of standby/hibernation before connecting. Notes • The Remote Commander uses the battery when connected to the PC. When you finish the setup, unplug from the USB connector. • If "E" is shown in the display, the Remote Commander cannot be recognized on your PC. Before connecting the Remote Commander to your PC, be sure to install fresh batteries in the Remote Commander. • Do not disconnect the USB cable from your PC while your PC is communicating with the Remote Commander, as a malfunction may occur. • Only connect one Remote Commander to your PC at a time. Otherwise, you will not be able to download the settings correctly. 1 Connect the USB cable to the USB connector of the Remote Commander. Using the "AX Remote Editor" to set up the Remote Commander You can set the Remote Commander using the "AX Remote Editor." Follow the procedures below. Note "AX1400 Remote Editor" does not start up when you do not log in as Administrator. 1 Gather all your remote controls. We recommend using the remote controls which were supplied with each component, but if you are using a replacement remote control (due to loss or damage) or a universal remote (which controls multiple components), have it handy as well. 2 On your PC, click the Windows "Start" button and point to "All Programs" - "Sony Remote AX," "AX Remote Editor" and click. "AX Remote Editor" starts up, and the last project appears. The first time "AX Remote Editor" starts up, "Startup Wizard" appears. Following the on-screen instructions, create a project. 2 Connect the USB cable to the USB connector of your PC. Getting Started 19