Sony RM-NX7000 Operating Instructions - Page 246
Trouble with the USB connection, Trouble with installing NAVITUS Design and transferring
View all Sony RM-NX7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 246 highlights
Continued Troubleshooting Trouble with the USB connection Symptom A beep sounds twice and data cannot be transferred even if the USB cable is connected. The USB cable cannot be detected even if it is connected. The USB connection is disconnected. Remedy • You may have locked the operation mode. While pressing the [EXIT] button, press and hold the [VOL-] button, and while pressing these two buttons, press the [CH-] button (page 38). The operation lock will be released. • The settings are locked and cannot be edited. Release the lock (page 223). • Check that the AC power adaptor is connected. The USB cable cannot be detected if the AC power adaptor is not detected. Connect the AC power adaptor to the Remote Commander. • The AC power adaptor may be disconnected, or the Remote Commander may be unloaded from the Battery charging stand. Connect the AC power adaptor to the Remote Commander, and perform the USB connection again. Trouble with installing "NAVITUS Design" and transferring data Symptom "NAVITUS Design" cannot be installed properly. "NAVITUS Design" software does not start, or you cannot select an item from the menu. Remedy • Read "Setting up the Remote Commander using "NAVITUS Design"" (page 25) in this manual and reinstall the software. • The software has not been installed properly. There may be some problem with the compatibility of the hardware or the software of your computer. Uninstall the "NAVITUS Design" software, and install it again. 246