Sony RM-TP1 Operating Instructions / Mode d’emploi - Page 26

Learning the commands of other remote commanders (continued) 5 Point the remote code receiver section of this commander toward the receiver/ transmitter on the remote control to be learned. 8 Touch . About 5 cm - 15 cm 6 Touch the key on this commander you want to use the Learning function ("N" for example). A mark (s) blinks in the bottom right corner of the key. Perform step 7 within 30 seconds after the mark starts blinking. 7 Press the appropriate button on the remote control to send the remote control code. Press the button more than 1 second. When this commander receives the remote control code and the learning is successful, the mark (s) in the bottom right corner stops blinking, and another mark (x) appears in the upper right corner of the key. 9 Touch USE in the pull-down menu. The commander returns to the operation mode. To use the Learning function for the buttons on the front panel Use the Learning function for the same named keys in the operation screen for AMP or TV. Example: When you use the Learning function for the MUTING key in the operation screen for AMP, the MUTING button on the front panel is also registered with the same code. To clear the learned code Perform steps 1 to 4 above, and touch the key you want to clear the learned code. The following display appears. Touch CLEAR to clear the learned code. To overwrite the learned code Perform steps 1 to 5 above, and touch the key you want to overwrite the learned code. The same display as "To clear the learned code" appears. Touch OVER WRITE. A mark (s) blinks in the bottom right corner of the key. Then follow steps 7 to 9. 26GB