Sony SAT-HD100 Operating Instructions (primary manual) (Large File - 19.43 MB - Page 8

Step 1: Connecting the Antennas or Cable TV 1 If you have a local TV antenna or cable company service Connect it to the VHF/UHF IN jack on your Digital Satellite Receiver using a coaxial cable or RF adapter (not supplied). The SATELLITE IN jack sends power to, and receives satellite signals from, the Satellite Dish Antenna. The VHF/UHF IN and VHF/UHF IN (DTV) jacks receive signals from your TV antenna(s) or cable company service. 1 2 2 If you have a Digital TV antenna Connect it to the VHF/UHF IN (DTV) jack on your Digital Satellite Receiver using a coaxial cable or RF adapter (not supplied). If you have a Satellite Dish Antenna Connect it to the SATELLITE IN jack on your Digital Satellite Receiver using RG-6 coaxial cable (not supplied). VHF/UHF IN SATELLITE IN VHF/UHF IN (DTV) VHF(SAT)/UHF OUT Digital Satellite Receiver VCR CONTROL LOW SPEED DATA RF REMOTE ACCESS CARD S VIDEO DIGITAL AUDIO L OUT (OPTICAL) R V 1 (MON VGA OUT AUDIO AUDIO/VIDE RG-6 Coaxial Cable from Satellite Dish Antenna CAUTION Only connect your authorized Satellite Dish Antenna to the SATELLITE IN jack as described in the Installation Instructions. Connecting any other equipment to this jack could result in damage to the equipment and/or receiver. Note Your Satellite Dish Antenna Installation Instructions provides detailed instructions on how to install RG-6 coaxial cable from your Satellite Dish Antenna. z Tip For best reception performance, use the Sony SAN-18D3 or SAN-24MD1 Satellite Dish Antenna. 8