Sony SDM-X202 Operating Instructions - Page 16

Adjust the picture's position manually (H Center /V Center) If the picture is not in the center of the screen, adjust the picture's centering as follows. 1 2 3 Set the resolution to 1600 × 1200 on the computer. Load the Utility Disk. Start the Utility Disk and display the test pattern. For Windows Click [Utility] t [Windows]/[Win Utility.exe]. For Macintosh Click [Utility] t [Mac]/[Mac Utility]. Press the MENU button. The main menu appears on the screen. Press the M/m buttons to select (INPUT SETTING) and press the OK button. The INPUT SETTING menu appears on the screen. Press the M/m buttons to select "H Center" or "V Center" and press the OK button. The "H Center" adjustment menu or "V Center" adjustment menu appears on the screen. Press the M/m buttons to center the test pattern on the screen. Click [END] on the screen to turn off the test pattern. x Selecting the input priority When connecting computers to both of the monitor's video input connectors for INPUT2 (DVI-D and HD15), you can choose the connector to which a signal is input preferentially. INPUT SETTING Auto Adjust Phase : Pitch : H Center : V Center : Input2 Priority : 1: HD15 20 0 50 50 DVI-D HD15 1600 × 1200/60 Hz Select Set OK Exit MENU 1 4 Press the MENU button. The main menu appears on the screen. Press the M/m buttons to select (INPUT SETTING) and press the OK button. The INPUT SETTING menu appears on the screen. Press the M/m buttons to select "Input2 Priority" and press the OK button. The options are displayed on the popup menu. Press the M/m buttons to select the desired mode. • DVI-D (The default setting): The signal input to the DVI-D input connector (digital RGB) for INPUT2 is displayed preferentially. • HD15: The signal input to the HD15 input connector (analog RGB) for INPUT2 is displayed preferentially. 2 5 3 6 4 7 8 If the monitor stays in the power saving mode and does not resume Carry out the following procedures if the monitor stays in the power saving mode and does not resume when the computer being activated is connected to a video input connector for INPUT2 other than the one selected in "Input2 Priority." 1 Press the 1 (power) switch. An INFORMATION message ("No input signal") appears on the screen. Press the MENU button while the INFORMATION message is being displayed. The "Input2 Priority" screen from the INPUT SETTING menu appears on the screen. Press the M/m buttons to select the input you want to display on the screen. 2 3 16