Sony SRS-X88 Operating Instructions - Page 3

either absence of information to transmit or For all other batteries, please view the section on operational failure. how to remove the battery from the product Frequency Tolerance: ±20ppm safely. Hand the battery over to the applicable collection point for the recycling of waste 5.15-5.25 GHz band is restricted to indoor operations only. batteries. For more detailed information about recycling of this product or battery, please contact your local Important Safety Instructions Civic Office, your household waste disposal service or the shop where you purchased the product. 1) Read these instructions. 2) Keep these instructions. For customers in Canada 3) Heed all warnings. 4) Follow all instructions. This device complies with Industry Canada licence- US exempt RSS standard(s). Operation is subject to 5) Do not use this apparatus near water. the following two conditions: (1) this device may 6) Clean only with dry cloth. not cause interference, and (2) this device must 7) Do not block any ventilation openings. Install in accept any interference, including interference accordance with the manufacturer's that may cause undesired operation of the device. instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the High-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices. polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or Outdoor use of the 5 GHz Wi-Fi function is prohibited by law. Compliance with IC requirement RSS-210 A9.4.4 the third prong are provided for your safety. If Data transmission is always initiated by software, the provided plug does not fit into your outlet, consult an electrician for replacement of the which is the passed down through the MAC, through the digital and analog baseband, and obsolete outlet. finally to the RF chip. Several special packets are 10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11) Only use attachments/accessories specified by the manufacturer. 12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use initiated by the MAC. These are the only ways the digital baseband portion will turn on the RF transmitter, which it then turns off at the end of the packet. Therefore, the transmitter will be on only while one of the aforementioned packets is being transmitted. In other words, this device automatically discontinues transmission in case of either absence of information to transmit or operational failure. caution when moving the cart/apparatus combination to avoid injury from tip-over. 13) Unplug this apparatus during lightning storms or when unused for long periods of time. 14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. For the state of California, USA only Perchlorate Material - special handling may apply, See www.dtsc.ca.gov/hazardouswaste/ perchlorate 3US