Sony SRS-XG300 Help Guide - Page 55

Help Guide Wireless Speaker SRS-XG300 Listening to music wirelessly with 2 speakers (Stereo Pair function) To use the Stereo Pair function, 2 SRS-XG300 speakers are required. By connecting 2 speakers via BLUETOOTH connection, you can enjoy more powerful sound. 2 speakers connected via BLUETOOTH connections play sounds in stereo, where 1 speaker plays the sound on the right channel (right side) and the other plays the sound on the left channel (left side). Before operating the speaker, make sure of the following: Update the pre-installed software to the latest version on each and every speaker to connect for the function. (For details about the update procedure, see Updating the pre-installed software.) Make sure that the 2 speakers to connect for the function are located within 1 m (3.2 ft) from each other. Stop music playback if it is in progress. You can establish or disconnect a connection for the Stereo Pair function with "Sony | Music Center." For details about "Sony | Music Center," refer to the following URL: https://www.sony.net/smcqa/ Note While the Stereo Pair function is in use, the speaker is not capable of outputting the music playing on the device that is connected to the AUDIO IN jack by an audio cable. While the speaker is in AUDIO IN mode, you can set it up for the Stereo Pair function with "Sony | Music Center" as well. Upon completion of the setup, however, the speaker is automatically placed into BLUETOOTH mode. Connecting a portable audio device or an equivalent to the AUDIO IN jack automatically places the speaker into AUDIO IN mode and deactivates the Stereo Pair function. To avoid any sudden loud sound output from the speaker, turn down the volume of the speaker and a BLUETOOTH device or stop the playback on the BLUETOOTH device before establishing a connection with the BLUETOOTH device. Hint Use of the Stereo Pair function automatically switches the codec to SBC. Turning off the speakers does not turn off the Stereo Pair function. When one of the speakers is turned back on, it attempts to establish a connection for the Stereo Pair function. To use the Stereo Pair function, turn on the other speaker within 1 minute. When the BLUETOOTH standby function remains active* on both of the speakers, however, turning on either of the speakers automatically turns on the other and establish a connection for the Stereo Pair function between the speakers. * As long as the speaker is connected to an AC outlet by the supplied AC adaptor, the BLUETOOTH standby function is turned on. Related Topic Using the BLUETOOTH standby (auto power on) function Installing "Sony | Music Center" Updating the pre-installed software 55