Sony SRSDB500 Operating Instructions - Page 16
Additional Information, Troubleshooting - 2 1 channel computer speakers
UPC - 027242754966
View all Sony SRSDB500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Additional Information Troubleshooting Should you encounter a problem with your speaker system, check the following list and take the indicated measures. If the problem persists, consult your nearest Sony dealer. When the "/1 indicator flashes Immediately unplug the power cord, and check the following items. • Are you using only the supplied speakers? • Are the + and - speaker cords short-circuited? • Is anything blocking the ventilation holes on the rear of the subwoofer unit? After checking the above items and fixing any problems, wait for 5 minutes before plug in the power cord again and turn on the system. If the "/1 indicator still flashes, or if the cause of the problem cannot be found even after checking all the above items, consult your nearest Sony dealer. General There is no sound. • Turn JOG clockwise (or press VOLUME + on the remote). • Turn up the volume on the connected device. • Check that headphones are not connected. • Check the speaker connections. • Make sure the muting function is turned off. • Check that you have selected the correct device with the INPUT button. 16US The sound is distorted. • Turn JOG counterclockwise. • Turn down the volume level on the connected device. Or, if the connected device has a BASS BOOST function, set it to off. There is hum or noise in the speaker output. • Make sure all the connections have been correctly made. • Make sure the connected device are not positioned too close to the TV set or monitor. The sound has suddenly stopped. • Make sure all the connections have been correctly made. • Make sure the muting function is turned off. There is no sound output from the headphone. • Check the headphone connection. • Check that the audio source on the selected channel is played back. • Make sure the muting function is turned off. The remote does not function. • Remove the obstacles between the remote and the unit. • Move the remote closer to the unit. • Point the remote at the unit's sensor. • Replace the batteries. • Move the unit away from the fluorescent light.