Sony STR-AV550 Operating Instructions - Page 33
Sony STR-AV550 Manual
View all Sony STR-AV550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
TROUBLESHOOTING PROBLEM ! Sound is not heard. CAUS , : .',..,- , : • -_Sp •.;, c, -..- The speaker or program source equipment is not connected correctly. Connect the equipment correctly. The SPEAKERS selectors are not set Set the selectors correctly. (See page correctly. 5.) The MONITOR button has been pressed for a program source other than tape deck 2. Press to disengage it. The correct FUNCTION button is not Press the correct FUNCTION button. pressed. The function switch on the VCR is not set correctly. Set the switch appropriately. The volume is set to minimum. Increase the volume. One channel does not transmit audio, or the volume from the left and right speakers is unbalanced. The BALANCE control buttons are not set appropriately. The speaker or program source Is not connected correctly. Adjust the BALANCE control buttons. Connect the equipment correctly. There is an abrupt loss of sound A short-circuit problem activates the from one or both of the speakers, protective circuit. and the PROTECTOR indication a; flickers in the display window. = 75. aE Sound transmitted from the speakers The speakers are not connected is reversed. correctly. Turn off the receiver, eliminate the short-circuit problem and turn on the power again.If there is no shortcircuit, consult your nearest Sony dealer. Connect the right speaker to the R SPEAKER terminals and the left speaker to the L SPEAKER terminals. There is lack of bass sound or the instrument position is obscure. The speaker is connected with the polarities reversed. Connect the speaker with the correct ® e polarities. Severe hum or noise is heard. The connecting cords are not of shielded type. Use shielded type cords. A transformer, motor, TV or fluorescent light affects the connecting cord, Place the connecting cords in a location away from a transformer or motor, and at least 3 meters (10 feet) from a TV set or a fluorescent light. The audio components are too close to a TV set. If both are used at the same time, separate the TV from the audio components. The receiver is not grounded. Connect the ground wire to the antenna ground terminal. The connections are loose. Make secure connections. The plugs and jacks are dirty. Wipe the plugs and jacks with a cloth lightly dampened with alcohol. The Remote Commander does not operate. The batteries are exhausted. The MAIN POWER switch on the receiver is not depressed. Replace the,batteries with new ones. Depress the MAIN POWER switch. 33