Sony STR-DG500 Operating Instructions - Page 25

5: Preparing the receiver and the remote Setting the voltage selector If your receiver has a voltage selector on the rear panel, check that the voltage selector is set to the local power supply voltage. If not, use a screwdriver to set the selector to the correct position before connecting the AC power cord to a wall outlet. VOLTAGE SELECTOR 120V 220V 240V Connecting the AC power cord Connect the AC power cord to a wall outlet. AC power cord CENTER + - SURROUND BACK L + - R FRONT A RL RL FRONT B SPEAKERS To the wall outlet Note Install this system so that the power cord can be unplugged from the wall socket immediately in the event of trouble. Performing initial setup operations Before using the receiver for the first time, initialize the receiver by performing the following procedure. This procedure can also be used to return settings you have made to their factory defaults. Be sure to use the buttons on the receiver for this operation. 1,2 ?/1 SPEAKERS (OFF/A/B /A+B) AUTO CAL MIC PHONES VIDEO 3 IN/PORTABLE AV IN VIDEO L AUDIO R MULTI CHANNEL DECODING DISPLAY INPUT MODE INPUT SELECTOR MASTER VOLUME MEMORY/ TUNING ENTER MODE TUNING 2CH A.F.D. MOVIE MUSIC MULTI CH IN DIRECT 3 1 Press ?/1 to turn off the receiver. 2 Hold down ?/1 for 5 seconds. "PUSH" and "ENTER" appears on the display alternately. 3 Press MEMORY/ENTER. After "CLEARING" appears on the display for a while, "CLEARED" appears. The following items are reset to their factory settings. • All settings in the LEVEL, TONE, SUR, TUNER, AUDIO, VIDEO and SYSTEM menus. • The sound field memorized for each input and preset station. • All sound field parameters. • All preset stations. • All index names for inputs and preset stations. • MASTER VOLUME is set to "VOL MIN". • Input is set to "DVD". 25GB Getting Started