Sony STR-DG600 Operating Instructions - Page 34

Error and warning codes Error codes When an error is detected during Auto Calibration, an error code will appear on the display cyclically after each measurement process as follows: Error code t blank display t (error code t blank display)a) t PUSH t blank display t ENTER a)Appears when there are more than one error code. To rectify the error 1 Record down the error code. 2 Press the control button. 3 Press ?/1 to turn off the receiver. 4 Rectify the error. For details, see "Error code and remedies" below. 5 Turn on the receiver and perform Auto Calibration again (page 33). Error code and remedies Error code Explanation Remedies ERROR 10 The environment Make sure the is too noisy. environment is quiet during Auto Calibration. ERROR 11 The speakers are Place your speakers placed too near further away from the optimizer the optimizer microphone. microphone. ERROR 20 Front speakers Check the front are not detected speaker or only one front connection. speaker is detected. ERROR 21 Only one Check the surround surround speaker speaker is detected. connection. Error code Explanation Remedies ERROR 22 Only one surround back speaker is detected. Check the surround back speaker connection. If you connect only one surround back speaker, connect it to the SPEAKERS SURROUND BACK L terminal. ERROR 23 Surround back speaker is detected but surround speakers are not connected. Be sure to connect the surround speakers. Warning codes During Auto Calibration, the warning code provides information on the measurement result. The warning code will appear on the display cyclically as follows: Warning code t blank display t (warning code t blank display)b) t PUSH t blank display t ENTER b)Appears when there are more than one warning code. You can choose to ignore the warning code as the Auto Calibration function will automatically adjust the settings. You can also change the settings manually. To change the settings manually 1 Record down the warning code. 2 Press the control button. 3 Press ?/1 to turn off the receiver. 4 Follow the solution provided in the "Warning code and solution" below. 5 Turn on the receiver and perform Auto Calibration again (page 33). 34US