Sony STR-DN840 Operating Instructions (Large File - 14.22 MB) - Page 30
: Connecting the antennas (aerials), 6: Connecting to the network, System requirements - update
View all Sony STR-DN840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
5: Connecting the antennas (aerials) Before connecting the antennas (aerials), be sure to disconnect the AC power cord (mains lead). AM loop antenna (aerial) (supplied) FM wire antenna (aerial) (supplied) Notes • To prevent noise pickup, keep the AM loop antenna (aerial) away from the receiver and other equipment. • Be sure to fully extend the FM wire antenna (aerial). • After connecting the FM wire antenna (aerial), keep it as horizontal as possible. 6: Connecting to the network If you have an Internet connection, you can connect this receiver to the Internet as well. You can connect through a wireless or a wired LAN connection. System requirements The following system environment is required to use the network function of the receiver. A Broadband line connection A Broadband line connection to the Internet is required in order to listen to Sony Entertainment Network (SEN) and to update the software of the receiver. Modem This is the device that is connected to the broadband line to communicate with the Internet. Some of these devices are integrated with the router. Router • Use a router compatible with 100 Mbps or greater transmission speeds to enjoy content on your home network. • We recommend that you use a router equipped with the built-in DHCP (Dynamic Host Configuration Protocol) server. This function automatically assigns IP addresses on the LAN. • Use a wireless LAN router/access point if you want to use a wireless LAN connection. 30US