Sony STR-DN840 Operating Instructions (Large File - 14.22 MB) - Page 85
Using a bi-amplifier connection, Reverting back to the factory default settings, Other Operations - factory reset
View all Sony STR-DN840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Using a bi-amplifier connection 1 Select "Settings" from the home menu, then press . The Settings menu list appears on the TV screen. 2 Select "Speaker Settings", then press . 3 Select "Speaker Pattern", then press . 4 Select the appropriate speaker pattern so that there are no surround back speakers and front high speakers, then press . 5 Select "SB Assign", then press . 6 Select "Bi-Amp", then press . The same signals output from the SPEAKERS FRONT A terminals can be output from the SPEAKERS SURROUND BACK/ BI-AMP/ FRONT HIGH/ FRONT B terminals. To exit the menu Press HOME. Notes • Set the "SB Assign" to "Bi-Amp" before you perform Auto Calibration. • If you set the "SB Assign" to "Bi-Amp", the speaker level and distance settings of the surround back speakers and front high speakers become invalid, and those of the front speakers are used. Reverting back to the factory default settings You can clear all memorized settings and revert the receiver back to the factory default settings by performing the following procedure. This procedure can also be used to initialize the receiver before you use it for the first time. Be sure to use the buttons on the receiver to perform this operation. ?/1 1 Press ?/1 to turn off the receiver. 2 Hold down ?/1 for 5 seconds. The "CLEARING" appears on the display panel for a while, then changes to "CLEARED!". Changes or adjustments made to the settings are now reset to the defaults. Note It takes about a few minutes for the memory to be cleared completely. Do not turn the receiver off until "CLEARED!" appears on the display. Other Operations 85US