Sony STR-ZA3000ES Installation Guide - Page 13
List of messages after Auto Calibration measurements, Saving/loading settings of the receiver - firmware
View all Sony STR-ZA3000ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Connections & settings (multi room/single room) List of messages after Auto Calibration measurements • Code 31: Front speakers are not selected properly. Select the front speakers using SPEAKERS, and then perform Auto Calibration again. • Code 32, Code 33: -- Speakers were not detected or not connected properly. -- None of the front speakers are connected or only one front speaker is connected. -- Either the surround left or surround right speaker is not connected. -- A surround back speaker is connected only to the SPEAKERS SURROUND BACK/FRONT HIGH/FRONT B/BI-AMP/ZONE 2 R terminal. If connecting only one surround back speaker, connect it to the SPEAKERS SURROUND BACK/FRONT HIGH/ FRONT B/BI-AMP/ZONE 2 L terminal. -- Either the front high left or front high right speaker is not connected. The optimizer microphone is not connected. Make sure that the optimizer microphone is connected properly, and then perform Auto Calibration again. If the optimizer microphone is connected properly but the error code still appears, the optimizer microphone cable may be damaged. • Warning 40: The measurement process has been completed and a high noise level has been detected. You may be able to achieve better results if you try the process again in a quiet environment. • Warning 41, Warning 42: The input from the microphone is too large. -- The distance between the speaker and the microphone may be too small. Set them further apart, and then perform the measurement again. • Warning 43: The distance and position of a subwoofer cannot be detected. This may be caused by noise. Try performing the measurement in a quiet environment. • NO WARNING: There is no warning information. Saving/loading settings of the receiver You can save the settings to a USB flash drive and restore the saved settings to the receiver or to another receiver of the same model. Saving Loading To save the settings Insert a USB flash drive to the USB port on the front panel of the receiver. Select [Setup] - [Install Setup] - [Save/Load] - [Save] from the home menu. To load the settings Insert to the USB port on the front panel of the receiver a USB flash drive on which the settings are saved. Select [Setup] - [Install Setup] - [Save/Load] - [Load] from the home menu. Updating the firmware with a USB flash drive Make sure to perform the following steps when a firmware update is delivered. You can download the update firmware from the following website. http://www.sony.com/essupport Saving Updating New firmware 1 Copy the file for updating to the top level directory (just under the root directory) of the USB flash drive (FAT16 or FAT32 with more than 100 MB of free space). 2 Turn the receiver on. 3 Insert the USB flash drive into the USB port on the front panel of the receiver. 4 Select [Setup] - [System Setup] - [USB Update] from the home menu. [UPDATING...XXX%] will be displayed on the front display. The receiver will automatically reboot after the update completes. Note • It takes up to 50 minutes for the update to complete. 13GB