Sony SU-FL300L Instructions (SU-FL300M & SU-FL300L TV Stands) - Page 6

Step 2: Assembling the TV Stand 2 Attach the Rear Pillar to the Base Board and secure the two Cam-lock screws with a screwdriver. Rear Pillar WARNING If you allow the AC power cord to be pinched under or between pieces of equipment, this may result in a short circuit or an electric shock. If you stumble over the AC power cord or the connecting cable, the TV Stand may topple over and cause injury. Decide on the installation location and lay the TV Stand down before installing the TV. Since the TV is heavy, it is recommended that you decide on the installation location beforehand, and assemble the TV Stand on site. 1 Attach the Rear Pillar to the Base Board. 1 Tighten the two supplied Cam-lock screws to the Base Board. Cam-lock screw 2 Attach the Side Pillars to the Base Board. Secure the Side Pillars and the Base Board with the four supplied screws (+PWH5 × 25). Base Board Arrow direction shows front of the TV Stand. Side Pillar (L) Side Pillar (R) Screw (+PWH5 × 25) Note There are differences between the left and right pillars. Be sure to install each pillar on the correct side. 6 (US)