Sony VPL CS21 Quick Reference Guide - Page 23
Troubleshooting - cable
UPC - 027242693562
View all Sony VPL CS21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Troubleshooting If the projector appears to be operating erratically, try to diagnose and correct the problem using the following instructions. If the problem persists, consult with qualified Sony personnel. For details on the symptoms, see the Operating Instructions contained in the CD-ROM. Power/Picture Symptom Cause and Remedy The power is not turned on. • The power has been turned off and on with the ?/1 key at a short interval. c Wait for about 45 seconds before turning on the power. • The lamp cover is not secured. c Close the lamp cover securely. • The air filter cover is detached. c Attach the air filter cover securely. The powered tilt adjuster does not close. The AC power cord was unplugged with the power of the projector turned on. c Connect the power cord to the AC outlet again, turn on the power of the projector, then turn it off. No picture. • A cable is disconnected or the connections are wrong. c Check that the proper connections have been made. • The connections are wrong. c This projector is compatible with DDC2B (Digital Data Channel 2B). If your computer is compatible with DDC, turn the projector on according to the following procedures. 1 Connect the projector to the computer. 2 Turn the projector on. 3 Start the computer. • Input selection is incorrect. c Select the input source correctly using the INPUT key. • The computer signal is not set to output to an external monitor or set to output both to an external monitor and a LCD monitor of a computer. c Set the computer signal to output only to an external monitor. c Depending on the type of your computer, for example a notebook, or an all-in-one LCD type, you may have to switch the computer to output to the projector by pressing certain keys or by changing your computer's settings. For details, refer to the computer's operating instructions supplied with your computer. The picture is noisy. The picture from the INPUT A connector is colored strangely. Noise may appear on the background depending on the combination of the number of dots input from the connector and the numbers of pixels on the LCD panel. c Change the desktop pattern on the connected computer. The setting of "Input-A Signal Sel." on the Setup menu is incorrect. c Select "Auto", "Computer," "Video GBR" or "Component" correctly according to the input signal. Troubleshooting 11