Sony VPL DS100 Operating Instructions - Page 39
Maintenance, Replacing the Lamp - lamp life
UPC - 027242641426
View all Sony VPL DS100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Maintenance B Maintenance Maintenance 2 Open the lamp cover by loosening a screw with the Phillips screwdriver. Replacing the Lamp Replace the lamp with a new one in the following case. • When the lamp has burnt out or dims • "Please replace the LAMP." appears on the screen • The LAMP/COVER indicator lights up The lamp life varies depending on conditions of use. Use LMP-E180 Projector Lamp as the replacement lamp. When replacing the lamp after using the projector Turn off the projector, then unplug the power cord. Wait for at least an hour for the lamp to cool. Caution The lamp becomes a high temperature after turning off the projector with the I / 1 key. If you touch the lamp, you may scald your finger. When you replace the lamp, wait for at least an hour for the lamp to cool. Notes • If the lamp breaks, consult with qualified Sony personnel. • Pull out the lamp by holding the handle. If you touch the lamp, you may be burned or injured. • When removing the lamp, make sure it remains horizontal, then pull straight up. Do not tilt the lamp. If you pull out the lamp while tilted and if the lamp breaks, the pieces may scatter, causing injury. 1 Place a protective sheet (cloth) beneath the projector. Turn the projector over so you can see its underside. Note Be sure that the projector is stable after turning it over. Note For safety sake, do not loosen any other screws. 3 Loosen the two screws on the lamp unit with the Phillips screwdriver. Pull out the lamp unit by the handle. Screws on the lamp (2) Bottom Handle Maintenance 39