Sony VPL-DX125 Operating Instructions - Page 24
The Connection/Power Menu
View all Sony VPL-DX125 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
The Connection/Power Menu The Connection/Power menu is used for setting for the connections and power. Items Item descriptions LAN Settings IP Address Setup Auto (DHCP): The IP address is assigned automatically from the DHCP server such as a router. Manual: To specify the IP Address manually. WLAN Settings WLAN Connection*8 Input-A Signal Sel.*1 On/Off: Set the wireless output of the USB wireless LAN module (supplied) to On/Off. Auto/Computer/Video GBR/Component: When set to "Auto," selects the type of video signal input automatically when "Input-A" is selected. ECO Lamp Mode High/Standard/Low/Auto*5 *7: When set to "High," the image becomes brighter, and power consumption becomes higher. When set to "Low," power consumption is minimized; however, the image will be darker. When set to "Auto," brightness is adjusted automatically according to image content. Dark images are projected with brightness adjusted, leading to energy-saving. Bright images are projected brightly, without adjusting brightness. Auto Power Saving With No Input With Static Signal Standby Mode*6 Lamp Cutoff: The lamp turns off automatically and power consumption is reduced if no signal is input for more than 10 minutes. The lamp lights again when a signal is input or any key is pressed. In Lamp Cutoff, the ON/STANDBY indicator lights in orange. (page 40) Standby*2: If no signal is input to the unit for more than 10 minutes, the power turns off automatically, and the unit enters standby mode. Off: You can deactivate the With No Input. Lamp Dimming*4 *5 *7: If an image does not change for about 10 seconds, lamp output is gradually reduced (approximately 10% to 15%*3) from that set in the Lamp Mode. Automatically the lamp slowly darkens to approximately 30% of its lamp output according to the selected time (with no change to input signal) "5," "10," "15," "20" minutes or "Demo.," While dimming the lamp, the message "Lamp Dimming" appears. If you select "Demo.," the image will start to darken about 40 seconds later. When any change in signal is detected, or an operation (remote control or control panel) is performed, normal brightness is restored. Off: You can deactivate the With Static Signal. Standard/Low: When set to "Low," lowers power consumption in Standby mode. Direct Power On On/Off: When set to "On," you can turn the power on without going to Standby mode when the AC power cord is connected to a wall outlet. With the projector turned off, you can also unplug the AC power cord without going to Standby mode, regardless of the Direct Power On setting. 24 The Connection/Power Menu