Sony VPL-DX125 Operating Instructions - Page 8

B Preparation Connecting the Projector Notes • Make sure all the equipment is powered off when connecting the projector. • Use the proper cables for each connection. • Insert the cable plugs firmly; Loose connections may reduce performance of picture signals or cause a malfunction. When pulling out a cable, be sure to grip it by the plug, not the cable itself. • For more information, refer also to the instruction manuals of the equipment you are connecting. • Use a no-resistance audio cable. Connecting a Computer Connection with a computer is explained for each input signal. INPUT A For connecting a computer with an RGB output connector. Mini D-sub 15-pin cable (supplied) RGB output connector Computer Audio output connector Audio cable (Stereo mini plug) (not supplied) Note It is recommended that you set the resolution of your computer to 1024 × 768 pixels (VPL-DX145/ DX125) or 1280 × 800 pixels (VPL-DW125) for the external monitor. INPUT B For connecting a computer with an HDMI output connector. Computer HDMI output connector HDMI cable (not supplied) Notes • Use HDMI-compatible equipment which has the HDMI Logo. • Use a high speed HDMI cable(s) on which the cable type logo is specified. (Sony products are recommended.) • The HDMI connector of this projector is not compatible with DSD (Direct Stream Digital) Signal or CEC (Consumer Electronics Control) Signal. • It is recommended that you set the resolution of your computer to 1024 × 768 pixels (VPL-DX145/ DX125) or 1280 × 800 pixels (VPL-DW125) for the external monitor. 8 Connecting the Projector