Sony VPL-FE110 Operating Instructions - Page 43
Using the PC Card, Setting for Networking Function, Using the Remote Commander or a Mouse and Keyboard - vpl remote
View all Sony VPL-FE110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Preparation Using the PC Card The PC CARD slot of INPUT B (VPL-PX15) or INPUT C (VPL-FX50 and VPL-FE110U/M) on the projector accepts one PCMCIA Type II PC card. To connect to a LAN, it is required to insert the specified/ recommended LAN PC card (VPL-FE110U/M only) or wireless LAN PC card into this slot. You can also insert the recommended PC memory card into this slot. Storing the file created with Microsoft PowerPoint or Excel, or the image file in a memory card enables you to project a file or run a presentation without connecting to a computer. Notes • Do not turn off the projector or restart Windows CE of the projector while the PC card is writing or reading. • Make sure to use the specified/recommended LAN PC card, wireless LAN PC card or PC memory card. For the specified/recommended cards, see the supplied "Specified/recommended PC Card/Wireless LAN Access Point." • The driver software for the specified/recommended PC cards is installed into the projector at the factory. Installing any other driver software is not required and cannot be done. For inserting and removing the PC card, refer to the Operating Instructions of the projector. Using the Remote Commander or a Mouse and Keyboard x For VPL-PX15 and VPL-FX50 When you operate the projector for setting up the projector, running a slide show, etc., use the supplied Remote Commander. Before operation, set the PJ/ NETWORK select switch on the Remote Commander to NETWORK. You cannot connect a mouse and keyboard to the projector. x For VPL-FE110U/M When you operate the projector for setting up the projector, running a presentation, etc., use of the RMPJM610 remote commander (not supplied) or commercially available PS/2 mouse and keyboard is required. Note Connect the mouse and keyboard to the projector before connecting the power cord of the projector to the AC outlet. For connections of the mouse and keyboard, refer to the Operating Instructions of the projector. For operation of the RM-PJM610 remote commander (not supplied), refer to the Operating Instructions of the remote commander. Setting for Networking Function To activate the networking function of the projector, do the following setup. x For VPL-PX15 Set INPUT-B FUNC. in the INSTALL SETTING menu to ON. For detailed information, see the Operating Instructions of the projector. x For VPL-FX50 Set INPUT-C FUNC. in the INSTALL SETTING menu to ON. For detailed information, see the Operating Instructions of the projector. x For VPL-FE110U/M Set the INPUT C/RS-232C/RS-422A select switch on the rear panel to INPUT C. 7 (GB)