Sony VPL-FH36 Operating Instructions - Page 17
Setting the blending function to, project from multiple projectors, VPL-FH36/FH31 only
View all Sony VPL-FH36 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Setting the blending function to project from multiple projectors (VPL-FH36/FH31 only) 1 Install the projectors. Input a pattern, etc., to adjust the projected positions from multiple projectors. Set a different ID mode for each projector (page 27). 2 Enable the Edge Blending function. Display the main menu to set "Edge Blending" to "On" in the Installation menu. 3 Set the position of blending. Choose the position (top/bottom/left/ right) for blending. 4 Assign the blending width. Set the blending width according to the overlapping range for the source signal. Assign the position and width here. Blend Gamma correction Notes • The procedure shown above is for general guidance. Your own installation may vary according to the situation. • In the case of multiple projectors, use the color matching function (page 31) to adjust for differences in color and brightness. Note that more detailed adjustment for Edge Blending is possible using a PC application. For more details, consult with qualified Sony personnel. • When multiple projectors are set up in a line, the temperature inside the projectors may increase due to exhaust vent proximity, and an error indication may result. In this case, space the projectors farther apart and/or install deflection partitioning between them. For more details, consult with qualified Sony personnel. Projecting/Adjusting an Image 5 Adjust using "Zone Black Level Adj." Adjust each correction zone by "Zone Black Level Adj." for the most uniform black level between each zone. During this adjustment, a black image is automatically projected. 6 Set "Blend Gamma." Select the gamma mode in which the overlapping of images is least noticeable. Projecting an Image 17