Sony VPL-FH36 Operating Instructions - Page 27
The Operation Menu
View all Sony VPL-FH36 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Adjustments and Settings Using a Menu The Operation Menu The Operation Menu is used for setting for the operations by using the menu or the Remote Commander. Setting items Description Language Selects the language used in the menu and on-screen displays. Menu Position*1 Bottom Left/Center: For selecting the position of the menu displayed on the projected image. Status On: All on-screen statuses are enabled. Off: Turn off the on-screen displays except for the menus, message when turning off the power, and warning messages. IR Receiver Front & Rear/Front/Rear: Selects the remote control receivers (IR Receiver) on the front and rear of the projector. ID Mode Security Lock*2 All/1/2/3: Assigns an ID number to the projector. When set to "All," you can control the projector with the Remote Commander independently of the assigned ID Mode. Refer also to "ID MODE 1/2/3 switch" of the Remote Commander on page 7. On/Off: This function enables restriction of the projector to autherized users by password. The setting procedures for security locking are as follows: 1 Select "On" then press the ENTER key to display the setting menu. 2 Input the password with the MENU, V/v/B/b, and ENTER keys. (The default password setting is "ENTER, ENTER, ENTER, ENTER.") 3 Input a new password with the MENU, V/v/B/b, and ENTER keys. 4 Enter the password again to confirm. Enter the password when you turn on the projector after disconnecting and reconnecting the AC power cord. When it is set to "Off," you can cancel the security lock. You are required to input the password again. If you fail to enter the correct password after three consecutive times, the projector cannot be used. In this case, press the ?/1 key to go Standby mode then turn on the power again. Panel Key Lock On/Off: When set to "On," locks all the control panel keys of the projector. However, you can enable operation by performing the following even when "Panel Key Lock" is set to "On." • Press and hold the ?/1 key for approximately 10 seconds during Standby mode. c The projector turns on. • Press and hold the MENU key for approximately 10 seconds during power on. c "Panel Key Lock" is set to "Off" and enables operation of all control panel keys on the projector. Notes *1: Available for VPL-FH36/FH35/FH31/FH30 only *2: You will not be able to use the projector if you forget your password. If you call qualified Sony personnel because you have forgotten the password, you will be asked to verify the projector's serial number and your identity. (This process may differ in other countries/regions.) Once your identity has been confirmed, we will provide you with the password. The Operation Menu 27