Sony VPL-HW55ES Operating Instructions - Page 11
Connections and Preparations, Unpacking - with 3d glass
View all Sony VPL-HW55ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Connections and Preparations Connections and Preparations This section describes how to install the projector and screen, how to connect the equipment from which you want to project the picture, etc. Unpacking Check the carton to make sure it contains the following items: • Remote control (1) and Size AA (R6) manganese batteries (2) • AC power cord (1) • Lens cap (1) When you have purchased the projector, the lens cap is put onto the lens. Remove this lens cap when you use the projector. • 3D glasses (2) • Pouch for the 3D glasses (2) • USB charging cable (APY5244010020/ SONY) (1.2 m) (2) • Conversion cable (LAN(M)-MD03(J)/ SONY) (18 cm) (1) • Operating Instructions (this manual) • Operating Instructions for the 3D glasses (1) Inserting the batteries into the remote control Insert the batteries E side first as shown in the illustration. Inserting them forcibly or with the polarities reversed may cause a short circuit and may generate heat. Push and slide to open. CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. When you dispose of the battery, you must obey the law in the relative area or country. Installing batteries Two size AA (R6) batteries are supplied for Remote Control. To avoid risk of explosion, use size AA (R6) manganese or alkaline batteries. 11 GB